[PATCH v7 0/3] mmc: dw_mmc: add dw_mmc-k3

[Jaehoon Chung]

This patchset looks good to me.

Acked-by: Jaehoon Chung <jh80.chung at samsung.com>

Best Regards,
Jaehoon Chung

On 01/09/2014 11:35 PM, Zhangfei Gao wrote:
> v7:
> 0002:
> use undefined local value in suspend/resume
> 
> v6:
> 0002:
> Jaehoon pointed HIGHSPEED cap can be omitted if supports-highspeed is defined.
> Seungwon mentioned clk operation should be called after suspend.
> Remove k3_dwmmc_caps
> 
> V5:
> 0002:
> Follow advice from Arnd, 
> Update dt descirption and use of_property_for_each_u32 to get table number.
> 
> v4:
> Follow Arnd's suggestion abstracting specific tuning to clock,
> also because new version ip use different method and not use same tuning registers.
> 
> 0001 acked by Jaehoon
> 
> v3:
> 0001: 
> Put set/clear_bit DW_MMC_CARD_PRESENT in dw_mci_get_cd, 
> Since dw_mci_request will check DW_MMC_CARD_PRESENT before sending cmd
> 
> 0002:
> Follow suggestion from Chris, Kumar and Seungwon
> Sync to latest mmc-next, which is 3.12-rc2
> Remove enum dw_mci_k3_type etc
> 
> v2:
> Follow Jaehoon's suggestion
> Use slot-gpio.c handle cd pin
> Move table out to dts
> other suggestion
> 
> 
> Zhangfei Gao (3):
>   mmc: dw_mmc: use slot-gpio to handle cd pin
>   mmc: dw_mmc: add dw_mmc-k3 for k3 platform
>   clk: hisilicon: add hi3620_mmc_clks
> 
>  .../bindings/arm/hisilicon/hisilicon.txt           |   14 ++
>  .../devicetree/bindings/clock/hi3620-clock.txt     |    1 +
>  .../devicetree/bindings/mmc/k3-dw-mshc.txt         |   60 +++++
>  drivers/clk/hisilicon/clk-hi3620.c                 |  262 ++++++++++++++++++++
>  drivers/mmc/host/Kconfig                           |   10 +
>  drivers/mmc/host/Makefile                          |    1 +
>  drivers/mmc/host/dw_mmc-k3.c                       |  126 ++++++++++
>  drivers/mmc/host/dw_mmc.c                          |   48 +++-
>  include/dt-bindings/clock/hi3620-clock.h           |    5 +
>  9 files changed, 514 insertions(+), 13 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/mmc/k3-dw-mshc.txt
>  create mode 100644 drivers/mmc/host/dw_mmc-k3.c
>