[PATCH v5 0/9] USB Host support for OMAP5 uEVM (for 3.14)

[Roger Quadros]

Hi Benoit & Tony,

This patchset brings up USB Host ports and Ethernet port on
the OMAP5 uEVM board.

It depends on the TI Clock DT conversion patches [1] and is based
on 3.13-rc7

[1] - http://article.gmane.org/gmane.linux.ports.arm.kernel/289895

NOTE: I've tested this only on the OMAP5 uEVM board. Since the patchset
changes could affect OMAP3/4, it must be verified at least on
a Beagleboard and a Panda board before being pulled in.
I request someone to verify this on OMAP3/4 since I don't have access
to those boards at the moment. Thanks.

Changelog:

v5:
- Expose all clocks in the DT binding document for mfd:omap-usb-host
and mfd:omap-usb-tll

v4:
- Updated DT binding document for clock binding

v3:
- Rebased on top of 3.13-rc7

cheers,
-roger

Roger Quadros (9):
  mfd: omap-usb-host: Use resource managed clk_get()
  mfd: omap-usb-host: Get clocks based on hardware revision
  mfd: omap-usb-host: Update DT clock binding information
  mfd: omap-usb-tll: Update DT clock binding information
  ARM: dts: omap4: Update omap-usb-host node
  ARM: dts: omap5: Update omap-usb-host node
  ARM: dts: omap4-panda: Provide USB PHY clock
  ARM: dts: omap5-uevm: Provide USB PHY clock
  ARM: OMAP2+: Remove legacy_init_ehci_clk()

 .../devicetree/bindings/mfd/omap-usb-host.txt      |  23 +++
 .../devicetree/bindings/mfd/omap-usb-tll.txt       |  10 ++
 arch/arm/boot/dts/omap4-panda-common.dtsi          |   8 +-
 arch/arm/boot/dts/omap4.dtsi                       |   6 +
 arch/arm/boot/dts/omap5-uevm.dts                   |   8 +-
 arch/arm/boot/dts/omap5.dtsi                       |   6 +
 arch/arm/mach-omap2/pdata-quirks.c                 |  16 --
 drivers/mfd/omap-usb-host.c                        | 172 ++++++++++-----------
 8 files changed, 128 insertions(+), 121 deletions(-)

-- 
1.8.3.2