[RFC PATCH 6/9] mtd: nand: add sunxi NFC dt bindings doc

[boris brezillon]

On 08/01/2014 22:28, Arnd Bergmann wrote:
> On Wednesday 08 January 2014, Boris BREZILLON wrote:
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/mtd/sunxi-nand.txt
>> @@ -0,0 +1,71 @@
>> +Allwinner NAND Flash Controller (NFC)
>> +
>> +Required properties:
>> +- compatible : "allwinner,sun4i-nfc".
>> +- reg : shall contain registers location and length for data and reg.
>> +- interrupts : shall define the NFC interrupt.
>> +- #address-cells: shall be set to 1. Encode the nand CS.
>> +- #size-cells : shall be set to 0.
>> +- clocks : shall reference NFC clocks.
>> +- clock-names : NFC internal clock names. Shall contain :
>> +    * "ahb_clk" : AHB gating clock
>> +    * "sclk" : NFC clock
>> +
> One small request: Can we try to avoid the "NFC" name here? I think it's
> too overloaded and people may confuse it with near-field communication,
> which I'm sure will be supported in sunxi based devices at some point.
>
> It doesn't hurt to also mention that the function block is called
> nfc, but I think references to it are better named "nand", which is
> less confusing.

Sure, I'll remove references to the NFC acronym:
  - change compatible string to "allwinner,sun4i-nand"
  - avoid NFC references in the doc
  - rename the driver into sunxi-nand.c (formerly sunxi_nfc.c)

Do you see any other references to this acronym ?


Best Regards,

Boris
> 	Arnd