[RFC PATCH 3/9] of: mtd: add NAND timings retrieval support

[boris brezillon]

Hello Jason,

Le 08/01/2014 19:34, Jason Gunthorpe a écrit :
> On Wed, Jan 08, 2014 at 03:21:58PM +0100, Boris BREZILLON wrote:
>
>> +int of_get_nand_timings(struct device_node *np, struct nand_timings *timings)
>> +{
>> +	memset(timings, 0, sizeof(*timings));
>> +	of_property_read_u32(np, "tCLS-min", &timings->tCLS_min);
>> +	of_property_read_u32(np, "tCLH-min", &timings->tCLH_min);
>> +	of_property_read_u32(np, "tCS-min", &timings->tCS_min);
> [..]
>
> A while ago when discussing another controller it was pointed out
> these values are all auto-probable directly from the NAND via a ONFI
> defined GET FEATURE @0x01 query, and adding these timings to the DT
> was NAK'd..
>
> Basically you set the interface to the slowest ONFI timing mode, do
> the GET FEATURE to the NAND chip and then increase the interface speed
> to the highest mutually supported ONFI mode.

> Is there some reason you need to encode this in the DT?

What if the NAND does not support the ONFI interface (and this is
exactly the case for the NAND available on the cubietruck board:
H27UCG8T2ATR).

But I'm glag to hear about this ONFI feature :).
I'll add a function to retrieve these timings if the NAND support
the ONFI interface.

Best Regards,

Boris
>
> Jason