ARM: mm: Could I change module space size or place modules in vmalloc area?

[Gioh Kim]

> -----Original Message-----
> From: Russell King - ARM Linux [mailto:linux at arm.linux.org.uk]
> Sent: Friday, January 03, 2014 9:47 AM
> To: Gioh Kim
> Cc: 'Baruch Siach'; linux-mm at kvack.org; 'linux-arm-kernel'; 'HyoJun Im'
> Subject: Re: ARM: mm: Could I change module space size or place modules in
> vmalloc area?
> 
> On Fri, Jan 03, 2014 at 09:39:31AM +0900, Gioh Kim wrote:
> > Thank you for reply.
> >
> > > -----Original Message-----
> > > From: Baruch Siach [mailto:baruch at tkos.co.il]
> > > Sent: Thursday, January 02, 2014 7:14 PM
> > > To: Gioh Kim
> > > Cc: Russell King; linux-mm at kvack.org; linux-arm-kernel; HyoJun Im
> > > Subject: Re: ARM: mm: Could I change module space size or place
> > > modules in vmalloc area?
> > >
> > > Hi Gioh,
> > >
> > > On Thu, Jan 02, 2014 at 07:04:13PM +0900, Gioh Kim wrote:
> > > > I run out of module space because I have several big driver modules.
> > > > I know I can strip the modules to decrease size but I need debug
> > > > info
> > > now.
> > >
> > > Are you sure you need the debug info in kernel memory? I don't think
> > > the kernel is actually able to parse DWARF. You can load stripped
> > > binaries into the kernel, and still use the debug info with whatever
> tool you have.
> >
> > I agree you but driver developers of another team don't agree.
> > I don't know why but they say they will strip drivers later :-( So I
> > need to increase modules space size.
> 
> ARM can only branch relatively within +/- 32MB.  Hence, with a module
> space of 16MB, modules can reach up to a maximum 16MB into the direct-
> mapped kernel image.  As module space increases in size, so that figure
> decreases.  So, if module space were to be 40MB, the maximum size of the
> kernel binary would be 8MB.
> 
> You want to look at a line similar to this:
> 
>       .text : 0xc0008000 - 0xc031eda0   (3164 kB)
> 
> Also, note this:
> 
>     modules : 0xbf000000 - 0xc0000000   (  16 MB)
> 
> If the difference between the lowest module address (0xbf000000) and the
> highest of .text is greater than 32MB, it's impossible to load modules -
> they will fail to link.
> 
> What is the size of your kernel text? (show us the line(s) like the
above.)

My kernel size is about 8MB as below.
[    0.000000]     modules : 0x7f000000 - 0x80000000   (  16 MB)
[    0.000000]       .text : 0x80008000 - 0x8085d2b0   (8533 kB)

I think I can increase the modules space size into 20MB.
Thanks for your reply.

> 
> Thanks.
> 
> --
> FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation in
> database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
> Estimate before purchase was "up to 13.2Mbit".