[PATCH v2 1/2] Input: touchscreen-iproc: Add Broadcom iProc touchscreen driver

[Jonathan Richardson]

On 14-12-19 02:26 PM, Joe Perches wrote:
> On Fri, 2014-12-19 at 14:17 -0800, Jonathan Richardson wrote:
>> Add initial version of the Broadcom touchscreen driver.
> 
> more trivia:
> 
>> diff --git a/drivers/input/touchscreen/bcm_iproc_tsc.c b/drivers/input/touchscreen/bcm_iproc_tsc.c
> []
>> +static int get_tsc_config(struct device_node *np, struct iproc_ts_priv *priv)
>> +{
>> +	u32 val;
> []
>> +	if (of_property_read_u32(np, "debounce_timeout", &val) >= 0) {
>> +		if (val < 0 || val > 255) {
>> +			dev_err(dev, "debounce_timeout must be [0-255]\n");
>> +			return -EINVAL;
>> +		}
>> +		priv->cfg_params.debounce_timeout = val;
> 
> Doesn't the compiler generate a warning message
> about an impossible "unsigned < 0" test for all
> of these "val < 0" uses?
> 

Actually no it doesn't. The gcc output shows that neither -Wtype-limits
nor -Wextra are used to compile that file. I assume this is because
there would be just too many warnings.


>> +	}
>> +
>> +	if (of_property_read_u32(np, "settling_timeout", &val) >= 0) {
>> +		if (val < 0 || val > 11) {
> []
>> +	if (of_property_read_u32(np, "touch_timeout", &val) >= 0) {
>> +		if (val < 0 || val > 255) {
> []
>> +	if (of_property_read_u32(np, "average_data", &val) >= 0) {
>> +		if (val < 0 || val > 8) {
> []
>> +	if (of_property_read_u32(np, "fifo_threshold", &val) >= 0) {
>> +		if (val < 0 || val > 31) {
> 
>