[PATCH 6/8] ARM: shmobile: kzm9g dts: Move Ethernet node to BSC

[Geert Uytterhoeven]

Move the Ethernet node from the root of the device tree to the BSC node,
as its connected to the Bus State Controller.  This allows the system to
know the right position of the Ethernet node in the clock and PM domain
hierarchy, and manage the clock and PM domain appropriately.

Also rename the node's name from "lan9220" to "ethernet", to conform to
ePAPR generic name recomendations.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
---
v2:
  - s/confirm/conform/
  - Moved from kzm9g-reference to kzm9g
---
 arch/arm/boot/dts/sh73a0-kzm9g.dts | 28 +++++++++++++++-------------
 1 file changed, 15 insertions(+), 13 deletions(-)

diff --git a/arch/arm/boot/dts/sh73a0-kzm9g.dts b/arch/arm/boot/dts/sh73a0-kzm9g.dts
index fce37b96394d0ee3..3e8aacb6ca1f2d06 100644
--- a/arch/arm/boot/dts/sh73a0-kzm9g.dts
+++ b/arch/arm/boot/dts/sh73a0-kzm9g.dts
@@ -84,19 +84,6 @@
 		enable-active-high;
 	};
 
-	lan9220 at 10000000 {
-		compatible = "smsc,lan9220", "smsc,lan9115";
-		reg = <0x10000000 0x100>;
-		phy-mode = "mii";
-		interrupt-parent = <&irqpin0>;
-		interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
-		reg-io-width = <4>;
-		smsc,irq-push-pull;
-		smsc,save-mac-address;
-		vddvario-supply = <&reg_1p8v>;
-		vdd33a-supply = <&reg_3p3v>;
-	};
-
 	leds {
 		compatible = "gpio-leds";
 		led1 {
@@ -178,6 +165,21 @@
 	};
 };
 
+&bsc {
+	ethernet at 10000000 {
+		compatible = "smsc,lan9220", "smsc,lan9115";
+		reg = <0x10000000 0x100>;
+		phy-mode = "mii";
+		interrupt-parent = <&irqpin0>;
+		interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+		reg-io-width = <4>;
+		smsc,irq-push-pull;
+		smsc,save-mac-address;
+		vddvario-supply = <&reg_1p8v>;
+		vdd33a-supply = <&reg_3p3v>;
+	};
+};
+
 &cmt1 {
 	status = "okay";
 };
-- 
1.9.1