[PATCH v5 2/2] i2c: cadence: Check for errata condition involving master receive

[Harini Katakam]

Cadence I2C controller has the following bugs:
- completion indication is not given to the driver at the end of
a read/receive transfer with HOLD bit set.
- Invalid read transaction are generated on the bus when HW timeout
condition occurs with HOLD bit set.

As a result of the above, if a set of messages to be transferred with
repeated start includes any transfer following a read transfer,
completion is never indicated and timeout occurs.
Hence a check is implemented to return -EOPNOTSUPP for such sequences.

Signed-off-by: Harini Katakam <harinik at xilinx.com>
Signed-off-by: Vishnu Motghare <vishnum at xilinx.com>
---

v5:
Make warning grepable in driver.

v4:
Use single dev_warn and make message grep-able.

v3:
Add warning in case of unsupported transfer.

v2:
Dont defeteature repeated start. Just check for unsupported conditions in the
driver and return error.

---
 drivers/i2c/busses/i2c-cadence.c |   12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/drivers/i2c/busses/i2c-cadence.c b/drivers/i2c/busses/i2c-cadence.c
index 5f5d4fa..6538c6c 100644
--- a/drivers/i2c/busses/i2c-cadence.c
+++ b/drivers/i2c/busses/i2c-cadence.c
@@ -541,6 +541,18 @@ static int cdns_i2c_master_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs,
 	 * processed with a repeated start.
 	 */
 	if (num > 1) {
+		/*
+		 * This controller does not give completion interrupt after a
+		 * master receive transfer if HOLD bit is set (repeated start),
+		 * resulting in SW timeout. Hence, if a receive transfer is
+		 * followed by any other transfer, an error is returned
+		 * indicating that this sequence is not supported.
+		 */
+		for (count = 0; count < num-1; count++) {
+			if (msgs[count].flags & I2C_M_RD)
+				dev_warn(adap->dev.parent, "No support for repeated start when receive is followed by a transfer\n");
+				return -EOPNOTSUPP;
+		}
 		id->bus_hold_flag = 1;
 		reg = cdns_i2c_readreg(CDNS_I2C_CR_OFFSET);
 		reg |= CDNS_I2C_CR_HOLD;
-- 
1.7.9.5