[PATCH v2 1/3] i2c: cadence: Handle > 252 byte transfers
Harini Katakam
harinik at xilinx.com
Wed Dec 3 04:35:24 PST 2014
The I2C controller sends a NACK to the slave when transfer size register
reaches zero, irrespective of the hold bit. So, in order to handle transfers
greater than 252 bytes, the transfer size register has to be maintained at a
value >= 1. This patch implements the same.
The interrupt status is cleared at the beginning of the isr instead of
the end, to avoid missing any interrupts - this is in sync with the new
transfer handling.
Signed-off-by: Harini Katakam <harinik at xilinx.com>
---
v2:
No changes
---
drivers/i2c/busses/i2c-cadence.c | 156 ++++++++++++++++++++------------------
1 file changed, 81 insertions(+), 75 deletions(-)
diff --git a/drivers/i2c/busses/i2c-cadence.c b/drivers/i2c/busses/i2c-cadence.c
index 63f3f03..e54899e 100644
--- a/drivers/i2c/busses/i2c-cadence.c
+++ b/drivers/i2c/busses/i2c-cadence.c
@@ -126,6 +126,7 @@
* @suspended: Flag holding the device's PM status
* @send_count: Number of bytes still expected to send
* @recv_count: Number of bytes still expected to receive
+ * @curr_recv_count: Number of bytes to be received in current transfer
* @irq: IRQ number
* @input_clk: Input clock to I2C controller
* @i2c_clk: Maximum I2C clock speed
@@ -144,6 +145,7 @@ struct cdns_i2c {
u8 suspended;
unsigned int send_count;
unsigned int recv_count;
+ unsigned int curr_recv_count;
int irq;
unsigned long input_clk;
unsigned int i2c_clk;
@@ -180,14 +182,15 @@ static void cdns_i2c_clear_bus_hold(struct cdns_i2c *id)
*/
static irqreturn_t cdns_i2c_isr(int irq, void *ptr)
{
- unsigned int isr_status, avail_bytes;
- unsigned int bytes_to_recv, bytes_to_send;
+ unsigned int isr_status, avail_bytes, updatetx;
+ unsigned int bytes_to_send;
struct cdns_i2c *id = ptr;
/* Signal completion only after everything is updated */
int done_flag = 0;
irqreturn_t status = IRQ_NONE;
isr_status = cdns_i2c_readreg(CDNS_I2C_ISR_OFFSET);
+ cdns_i2c_writereg(isr_status, CDNS_I2C_ISR_OFFSET);
/* Handling nack and arbitration lost interrupt */
if (isr_status & (CDNS_I2C_IXR_NACK | CDNS_I2C_IXR_ARB_LOST)) {
@@ -195,89 +198,91 @@ static irqreturn_t cdns_i2c_isr(int irq, void *ptr)
status = IRQ_HANDLED;
}
- /* Handling Data interrupt */
- if ((isr_status & CDNS_I2C_IXR_DATA) &&
- (id->recv_count >= CDNS_I2C_DATA_INTR_DEPTH)) {
- /* Always read data interrupt threshold bytes */
- bytes_to_recv = CDNS_I2C_DATA_INTR_DEPTH;
- id->recv_count -= CDNS_I2C_DATA_INTR_DEPTH;
- avail_bytes = cdns_i2c_readreg(CDNS_I2C_XFER_SIZE_OFFSET);
-
- /*
- * if the tranfer size register value is zero, then
- * check for the remaining bytes and update the
- * transfer size register.
- */
- if (!avail_bytes) {
- if (id->recv_count > CDNS_I2C_TRANSFER_SIZE)
- cdns_i2c_writereg(CDNS_I2C_TRANSFER_SIZE,
- CDNS_I2C_XFER_SIZE_OFFSET);
- else
- cdns_i2c_writereg(id->recv_count,
- CDNS_I2C_XFER_SIZE_OFFSET);
- }
+ updatetx = 0;
+ if (id->recv_count > id->curr_recv_count)
+ updatetx = 1;
+
+ /* When receiving, handle data and transfer complete interrupts */
+ if (id->p_recv_buf &&
+ ((isr_status & CDNS_I2C_IXR_COMP) ||
+ (isr_status & CDNS_I2C_IXR_DATA))) {
+ while (cdns_i2c_readreg(CDNS_I2C_SR_OFFSET) &
+ CDNS_I2C_SR_RXDV) {
+ if ((id->recv_count < CDNS_I2C_FIFO_DEPTH) &&
+ !id->bus_hold_flag)
+ cdns_i2c_clear_bus_hold(id);
- /* Process the data received */
- while (bytes_to_recv--)
*(id->p_recv_buf)++ =
cdns_i2c_readreg(CDNS_I2C_DATA_OFFSET);
+ id->recv_count--;
+ id->curr_recv_count--;
- if (!id->bus_hold_flag &&
- (id->recv_count <= CDNS_I2C_FIFO_DEPTH))
- cdns_i2c_clear_bus_hold(id);
+ if (updatetx &&
+ (id->curr_recv_count == CDNS_I2C_FIFO_DEPTH + 1))
+ break;
+ }
- status = IRQ_HANDLED;
- }
+ if (updatetx &&
+ (id->curr_recv_count == CDNS_I2C_FIFO_DEPTH + 1)) {
+ /* wait while fifo is full */
+ while (cdns_i2c_readreg(CDNS_I2C_XFER_SIZE_OFFSET) !=
+ (id->curr_recv_count - CDNS_I2C_FIFO_DEPTH))
+ ;
- /* Handling Transfer Complete interrupt */
- if (isr_status & CDNS_I2C_IXR_COMP) {
- if (!id->p_recv_buf) {
- /*
- * If the device is sending data If there is further
- * data to be sent. Calculate the available space
- * in FIFO and fill the FIFO with that many bytes.
- */
- if (id->send_count) {
- avail_bytes = CDNS_I2C_FIFO_DEPTH -
- cdns_i2c_readreg(CDNS_I2C_XFER_SIZE_OFFSET);
- if (id->send_count > avail_bytes)
- bytes_to_send = avail_bytes;
- else
- bytes_to_send = id->send_count;
-
- while (bytes_to_send--) {
- cdns_i2c_writereg(
- (*(id->p_send_buf)++),
- CDNS_I2C_DATA_OFFSET);
- id->send_count--;
- }
+ if (((int)(id->recv_count) - CDNS_I2C_FIFO_DEPTH) >
+ CDNS_I2C_TRANSFER_SIZE) {
+ cdns_i2c_writereg(CDNS_I2C_TRANSFER_SIZE,
+ CDNS_I2C_XFER_SIZE_OFFSET);
+ id->curr_recv_count = CDNS_I2C_TRANSFER_SIZE +
+ CDNS_I2C_FIFO_DEPTH;
} else {
- /*
- * Signal the completion of transaction and
- * clear the hold bus bit if there are no
- * further messages to be processed.
- */
- done_flag = 1;
+ cdns_i2c_writereg(id->recv_count -
+ CDNS_I2C_FIFO_DEPTH,
+ CDNS_I2C_XFER_SIZE_OFFSET);
+ id->curr_recv_count = id->recv_count;
}
- if (!id->send_count && !id->bus_hold_flag)
- cdns_i2c_clear_bus_hold(id);
- } else {
+ }
+
+ if ((isr_status & CDNS_I2C_IXR_COMP) && !id->recv_count) {
if (!id->bus_hold_flag)
cdns_i2c_clear_bus_hold(id);
+ done_flag = 1;
+ }
+
+ status = IRQ_HANDLED;
+ }
+
+ /* When sending, handle transfer complete interrupt */
+ if ((isr_status & CDNS_I2C_IXR_COMP) && !id->p_recv_buf) {
+ /*
+ * If the device is sending data If there is further
+ * data to be sent. Calculate the available space
+ * in FIFO and fill the FIFO with that many bytes.
+ */
+ if (id->send_count) {
+ avail_bytes = CDNS_I2C_FIFO_DEPTH -
+ cdns_i2c_readreg(CDNS_I2C_XFER_SIZE_OFFSET);
+ if (id->send_count > avail_bytes)
+ bytes_to_send = avail_bytes;
+ else
+ bytes_to_send = id->send_count;
+
+ while (bytes_to_send--) {
+ cdns_i2c_writereg(
+ (*(id->p_send_buf)++),
+ CDNS_I2C_DATA_OFFSET);
+ id->send_count--;
+ }
+ } else {
/*
- * If the device is receiving data, then signal
- * the completion of transaction and read the data
- * present in the FIFO. Signal the completion of
- * transaction.
+ * Signal the completion of transaction and
+ * clear the hold bus bit if there are no
+ * further messages to be processed.
*/
- while (cdns_i2c_readreg(CDNS_I2C_SR_OFFSET) &
- CDNS_I2C_SR_RXDV) {
- *(id->p_recv_buf)++ =
- cdns_i2c_readreg(CDNS_I2C_DATA_OFFSET);
- id->recv_count--;
- }
done_flag = 1;
}
+ if (!id->send_count && !id->bus_hold_flag)
+ cdns_i2c_clear_bus_hold(id);
status = IRQ_HANDLED;
}
@@ -287,8 +292,6 @@ static irqreturn_t cdns_i2c_isr(int irq, void *ptr)
if (id->err_status)
status = IRQ_HANDLED;
- cdns_i2c_writereg(isr_status, CDNS_I2C_ISR_OFFSET);
-
if (done_flag)
complete(&id->xfer_done);
@@ -314,6 +317,8 @@ static void cdns_i2c_mrecv(struct cdns_i2c *id)
if (id->p_msg->flags & I2C_M_RECV_LEN)
id->recv_count = I2C_SMBUS_BLOCK_MAX + 1;
+ id->curr_recv_count = id->recv_count;
+
/*
* Check for the message size against FIFO depth and set the
* 'hold bus' bit if it is greater than FIFO depth.
@@ -333,10 +338,11 @@ static void cdns_i2c_mrecv(struct cdns_i2c *id)
* receive if it is less than transfer size and transfer size if
* it is more. Enable the interrupts.
*/
- if (id->recv_count > CDNS_I2C_TRANSFER_SIZE)
+ if (id->recv_count > CDNS_I2C_TRANSFER_SIZE) {
cdns_i2c_writereg(CDNS_I2C_TRANSFER_SIZE,
CDNS_I2C_XFER_SIZE_OFFSET);
- else
+ id->curr_recv_count = CDNS_I2C_TRANSFER_SIZE;
+ } else
cdns_i2c_writereg(id->recv_count, CDNS_I2C_XFER_SIZE_OFFSET);
/* Clear the bus hold flag if bytes to receive is less than FIFO size */
if (!id->bus_hold_flag &&
--
1.7.9.5
More information about the linux-arm-kernel
mailing list