[PATCH v3 05/11] memory: add Atmel EBI (External Bus Interface) driver

[Alexander Stein]

Hi Boris,

On Monday 01 December 2014 11:27:21, Boris Brezillon wrote:
> The EBI (External Bus Interface) is used to access external peripherals
> (NOR, SRAM, NAND, and other specific devices like ethernet controllers).
> Each device is assigned a CS line and an address range and can have its
> own configuration (timings, access mode, bus width, ...).
> This driver provides a generic DT binding to configure a device according
> to its requirements.
> For specific device controllers (like the NAND one) the SMC timings
> should be configured by the controller driver through the matrix and
> smc syscon regmaps.
> 
> Signed-off-by: Jean-Jacques Hiblot <jjhiblot at traphandler.com>
> Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
> ---
>  drivers/memory/Kconfig     |  11 +
>  drivers/memory/Makefile    |   1 +
>  drivers/memory/atmel-ebi.c | 627 +++++++++++++++++++++++++++++++++++++++++++++
>  3 files changed, 639 insertions(+)
>  create mode 100644 drivers/memory/atmel-ebi.c

While I like this feature, shouldn't this driver go to drivers/bus/ like the imx-weim driver? The latter one does the same, so I wonder why one is in drivers/bus while the other is in drivers/memory.

Best regards,
Alexander
-- 
Dipl.-Inf. Alexander Stein

SYS TEC electronic GmbH
Am Windrad 2
08468 Heinsdorfergrund
Tel.: 03765 38600-1156
Fax: 03765 38600-4100
Email: alexander.stein at systec-electronic.com
Website: www.systec-electronic.com
 
Managing Director: Dipl.-Phys. Siegmar Schmidt
Commercial registry: Amtsgericht Chemnitz, HRB 28082