[RFC PATCH 1/2] ARM: imx: add BYPASS support for PLL clocks

[Shengjiu Wang]

On Fri, Aug 29, 2014 at 10:53:51AM +0800, Shawn Guo wrote:
> On Fri, Aug 29, 2014 at 09:49:50AM +0800, Shengjiu Wang wrote:
> > On Thu, Aug 28, 2014 at 04:44:21PM +0800, Shawn Guo wrote:
> > > On Tue, Aug 26, 2014 at 11:35:12PM +0800, Shawn Guo wrote:
> > > > The i.MX6 clock drivers currently hard-code all PLL clocks sourcing from
> > > > OSC24M without BYPASS support.  The patch adds BYPASS and BYPASS_CLK_SRC
> > > > selection for PLL clocks as per Figure 10-3. Primary Clock Generation
> > > > in IMX6DQRM, i.e. both BYPASS_CLK_SRC and BYPASS bits are implemented as
> > > > mux clocks, and ENABLE bit of PLL clocks is implemented as a gate clock
> > > > after BYPASS mux.
> > > > 
> > > > Signed-off-by: Shawn Guo <shawn.guo at freescale.com>
> > > 
> > > Shengjiu,
> > > 
> > > Can you please test if this BYPASS support works good for your ESAI use
> > > case?
> > > 
> > > Shawn
> > 
> > Yes, after test, one issue found. Please check.
> > 
> > -static const char *pll_bypass_src_sels[] = { "osc", "anaclk1", "anaclk2", "dummy", };
> > +static const char *pll_bypass_src_sels[] = { "osc", "lvds1_in", "lvds2_in", "dummy", };
> 
> Ah, yes.  I will fix my code.
> 
> So doest that mean with the above fix, we can now source 24.576MHz from
> board directly to ESAI with audio PLL in bypass mode?
> 
> Shawn

Otherwise I still need to do some step in below to source the clock to ESAI.

        clk_set_parent(pll4_bypass_src, lvds2_in);
        clk_set_parent(pll4_bypass, pll4_bypass_src);
        clk_set_rate(pll4_audio_div, 24576000);
        clk_set_rate(esai_extal, 24576000);

I think it is what we can expect, right? if yes, the patch is ok for ESAI.

wang shengjiu