[PATCH 0/4] Add reset support for apq8064

[Pramod Gurav]

The reset on apq8064 is provided on gpio78 function1. We need to configure
gpio78 to function as ps_hold and write to base of the register to get the
device rebooted. 

First two patches in this patchset adds necessary DT support for apq8064-pinctrl
and DT support to mux gpio_78 as ps_hold function.

Third patch documents the ps_hold function in apq8064-pinctrl DT binding

Fourth implements the actual reset by initialising arm_pm_restart to a reset
function if ps_hold function is programmed in the pinctrl driver.

This is v2 with below changes since v1:
1. Added #error log as suggested by Kumar Gala 
2. Correct interrupts in DT from 32 to 16 based on Bjorn's new patch in bindings
3. Replaced hardcoding in DT with IRQ_TYPE_LEVEL_HIGH for interrupt level type

Pramod Gurav (4):
  ARM: DT: APQ8064: Add pinctrl support
  ARM: DT: APQ8064: Add node for ps_hold function in pinctrl
  pinctrl: msm: Add ps_hold function in pinctrl-apq8064 binding
    documentation
  pinctrl: qcom: Add support for reset for apq8064

 .../bindings/pinctrl/qcom,apq8064-pinctrl.txt      |    2 +-
 arch/arm/boot/dts/qcom-apq8064.dtsi                |   21 +++++++++++
 drivers/pinctrl/qcom/pinctrl-apq8064.c             |    7 +++-
 drivers/pinctrl/qcom/pinctrl-msm.c                 |   38 ++++++++++++++++++++
 4 files changed, 66 insertions(+), 2 deletions(-)