[PATCH 1/2] doc: dt/bindings: input: introduce TI DRV2667 haptic driver description
Sergei Shtylyov
sergei.shtylyov at cogentembedded.com
Thu Aug 21 11:28:56 PDT 2014
Hello.
On 08/21/2014 10:19 PM, Dan Murphy wrote:
> DRV2667 is a haptic/vibrator driver for Linear Resonant Actuators.
> Adding dt binding for this part
> Signed-off-by: Dan Murphy <dmurphy at ti.com>
> ---
> .../devicetree/bindings/input/ti,drv2667.txt | 18 ++++++++++++++++++
> 1 file changed, 18 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/input/ti,drv2667.txt
> diff --git a/Documentation/devicetree/bindings/input/ti,drv2667.txt b/Documentation/devicetree/bindings/input/ti,drv2667.txt
> new file mode 100644
> index 0000000..525216d
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/input/ti,drv2667.txt
> @@ -0,0 +1,18 @@
> +Texas Instruments - drv2667 Haptics driver
> +
> +The drv2667 uses serial control bus communicates through I2C protocols
I can't parse that.
> +
> +Required properties:
> + - compatible - "ti,drv2667" - DRV2667
> + - reg - I2C slave address
> + - vbat-supply - Required supply regulator
> +
> +Example:
> +
> +drv2667: drv2667 at 59 {
> + compatible = "ti,drv2667";
> + reg = <0x59>;
You say "vbat-supply" is mandatory, yet you don't have it in your example?
WBR, Sergei
More information about the linux-arm-kernel
mailing list