[PATCH v9 8/9] arm: Seperate DEBUG_UART_PHYS from DEBUG_LL on EP93XX

[Daniel Thompson]

On EP93XX uncompress.h uses CONFIG_DEBUG_UART_PHYS instead of a hard
coded serial port. This means the build breaks when DEBUG_LL
(and DEBUG_LL_UART_PL01X) is not enabled.

This is fixed by adding a new dependancy.

Signed-off-by: Daniel Thompson <daniel.thompson at linaro.org>
Acked-by: Arnd Bergmann <arnd at arndb.de>
---
 arch/arm/Kconfig.debug | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index 227ae88..f92b98f 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -1219,7 +1219,8 @@ config DEBUG_UART_PHYS
 		DEBUG_LL_UART_EFM32 || \
 		DEBUG_UART_8250 || DEBUG_UART_PL01X || \
 		DEBUG_MSM_UART || DEBUG_NETX_UART || DEBUG_QCOM_UARTDM || \
-		DEBUG_S3C24XX_UART || DEBUG_SA1100_UART
+		DEBUG_S3C24XX_UART || DEBUG_SA1100_UART || \
+		ARCH_EP93XX
 
 config DEBUG_UART_VIRT
 	hex "Virtual base address of debug UART"
-- 
1.9.3