[PATCHv9 3/3] arm: dts: Add Altera SDRAM controller bindings

[Rob Herring]

On 07/30/2014 01:22 PM, tthayer at opensource.altera.com wrote:
> From: Thor Thayer <tthayer at opensource.altera.com>
> 
> Add the Altera SDRAM controller bindings and device tree changes to the Altera SoC project.
> 
> Signed-off-by: Thor Thayer <tthayer at opensource.altera.com>
> ---
> v2: Changes to SoC SDRAM EDAC code.
> 
> v3: Implement code suggestions for SDRAM EDAC code.
> 
> v4: Remove syscon from SDRAM controller bindings.
> 
> v5: No Change, bump version for consistency.
> 
> v6: Only map the ctrlcfg register as syscon.
> 
> v7: No change. Bump for consistency.
> 
> v8: No change. Bump for consistency.
> 
> v9: Changes to support a MFD SDRAM controller with nested EDAC.
> ---
>  .../devicetree/bindings/arm/altera/socfpga-sdr.txt |   13 +++++++++++++
>  arch/arm/boot/dts/socfpga.dtsi                     |   10 ++++++++++
>  2 files changed, 23 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/arm/altera/socfpga-sdr.txt
> 
> diff --git a/Documentation/devicetree/bindings/arm/altera/socfpga-sdr.txt b/Documentation/devicetree/bindings/arm/altera/socfpga-sdr.txt
> new file mode 100644
> index 0000000..2bb1ddf
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/arm/altera/socfpga-sdr.txt
> @@ -0,0 +1,13 @@
> +Altera SOCFPGA SDRAM Controller
> +The SDRAM controller is implemented as a MFD so various drivers may
> +nest under this main SDRAM controller binding.
> +
> +Required properties:
> +- compatible : "altr,sdr";
> +- reg : Should contain 1 register range(address and length)
> +
> +Example:
> +	sdr at 0xffc25000 {
> +		compatible = "altr,sdr";
> +		reg = <0xffc25000 0x1000>;
> +	};
> diff --git a/arch/arm/boot/dts/socfpga.dtsi b/arch/arm/boot/dts/socfpga.dtsi
> index 4676f25..ecb306d 100644
> --- a/arch/arm/boot/dts/socfpga.dtsi
> +++ b/arch/arm/boot/dts/socfpga.dtsi
> @@ -603,6 +603,16 @@
>  			};
>  		};
>  
> +		sdr at 0xffc25000 {
> +			compatible = "altr,sdr";
> +			reg = <0xffc25000 0x1000>;
> +
> +			sdramedac at 0 {
> +				compatible = "altr,sdram-edac";
> +				interrupts = <0 39 4>;
> +			};

This doesn't match the documentation, but I don't think this is a move
in the right direction anyway. Because Linux has/wants an MFD driver is
not a reason to add a sub node. It is a single h/w block and DT should
reflect that.

Rob