[PATCH v6 09/10] ARM: dts: Simplify USB3503 on exynos5250-arndale

Andreas Färber afaerber at suse.de
Fri Aug 1 17:52:29 PDT 2014


There's no need for a simple-bus, place the smsc,usb3503a directly into
the root node. That's what we're going to do on exynos5250-spring.

Reported-by: Tomasz Figa <t.figa at samsung.com>
Reviewed-by: Tomasz Figa <t.figa at samsung.com>
Signed-off-by: Andreas Färber <afaerber at suse.de>
---
 v5 -> v6: Unchanged
 
 v5: New
 Aligns with Spring's new USB3503 node.

 arch/arm/boot/dts/exynos5250-arndale.dts | 16 +++++-----------
 1 file changed, 5 insertions(+), 11 deletions(-)

diff --git a/arch/arm/boot/dts/exynos5250-arndale.dts b/arch/arm/boot/dts/exynos5250-arndale.dts
index cc8b9ffeecc1..b231bcff7403 100644
--- a/arch/arm/boot/dts/exynos5250-arndale.dts
+++ b/arch/arm/boot/dts/exynos5250-arndale.dts
@@ -108,18 +108,12 @@
 		};
 	};
 
-	usb_hub_bus {
-		compatible = "simple-bus";
-		#address-cells = <1>;
-		#size-cells = <0>;
+	// SMSC USB3503 connected in hardware only mode as a PHY
+	usb_hub: usb-hub {
+		compatible = "smsc,usb3503a";
 
-		// SMSC USB3503 connected in hardware only mode as a PHY
-		usb_hub: usb_hub {
-			compatible = "smsc,usb3503a";
-
-			reset-gpios = <&gpx3 5 GPIO_ACTIVE_LOW>;
-			connect-gpios = <&gpd1 7 GPIO_ACTIVE_LOW>;
-		};
+		reset-gpios = <&gpx3 5 GPIO_ACTIVE_LOW>;
+		connect-gpios = <&gpd1 7 GPIO_ACTIVE_LOW>;
 	};
 };
 
-- 
1.9.3




More information about the linux-arm-kernel mailing list