[PATCH 1/2] ARM: kirkwood: add support for OpenBlocks A7 platform

[Gregory CLEMENT]

On 31/10/2013 09:37, Thomas Petazzoni wrote:
> Dear Jason Cooper,
> 
> On Wed, 30 Oct 2013 15:57:25 -0400, Jason Cooper wrote:
> 
>>> +			partition at 0 {
>>> +				label = "uboot";
>>> +				reg = <0x0 0x1c0000>;
>>> +			};
>>> +
>>> +			partition at 90000 {
>>> +				label = "env";
>>> +				reg = <0x1c0000 0x2c0000>;
>>> +			};
>>
>> Hmm, something doesn't look right here.  Cut-n-paste problem?  Did you
>> run 'make dtbs' against this?  I get address size errors when I do.
> 
> Strange. 'make dtbs' was working here. What was wrong exactly? Just
> that the unit address (@90000) didn't match the starting address
> 0x1c0000 ?

The unit address has no special meaning for the device tree it's just a
way to give a unique name to a node right?

So in this case it is not really a problem, but it's just nicer for the
coherency of the information in the dt to have the unit address which match
the starting address.

I also do a make dtbs ans I didn't get any errors:
$ make dtbs
 [...]
  DTC     arch/arm/boot/dts/kirkwood-openblocks_a6.dtb
  DTC     arch/arm/boot/dts/kirkwood-openblocks_a7.dtb

Regards,
> 
>> let me know if it's ok with you and I'll push it tomorrow.
> 
> This all looks good to me!
> 
> Thanks a lot,
> 
> Thomas
> 


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com