[PATCH 1/2] leds: lp55xx: handle enable pin in driver

[Benoit Cousson]

On 23/10/2013 10:19, Tony Lindgren wrote:
> * Bryan Wu <cooloney at gmail.com> [131022 10:47]:
>> On Tue, Oct 22, 2013 at 10:37 AM, Tony Lindgren <tony at atomide.com> wrote:
>>> * Bryan Wu <cooloney at gmail.com> [131022 10:23]:
>>>> On Tue, Oct 22, 2013 at 10:06 AM, Tony Lindgren <tony at atomide.com> wrote:
>>>>> * Sebastian Reichel <sre at debian.org> [131022 06:02]:
>>>>>> This patch moves the handling of the chip's enable pin from the board
>>>>>> code into the driver. It also updates all board-code files using the
>>>>>> driver to incorporate this change.
>>>>>>
>>>>>> This is needed for device tree support of the enable pin.
>>>>>
>>>>> This seems safe to merge along with the other LED patches, the
>>>>> changes to arch/arm/mach-omap2 should not conflict with anything.
>>>>>
>>>>> So for the arch/arm/mach-omap2 changes:
>>>>>
>>>>> Acked-by: Tony Lindgren <tony at atomide.com>
>>>>
>>>> I'm OK for LED parts, will this patch go through omap tree? If so,
>>>> please add my ack.
>>>>
>>>> Acked-by: Bryan Wu <cooloney at gmail.com>
>>>
>>> It's probably best that you take it via with the LED patches.
>>>
>>
>> OK, I will do it. what about PATCH 2 of this patch set? Will you take
>> care of it?
>
> Benoit should take that one, otherwise there's a good chance of
> pointless merge conflicts with the .dts files.

I've just merged it.

Regards,
Benoit

-- 
Benoît Cousson
BayLibre
Embedded Linux Technology Lab
www.baylibre.com