[PATCH 1/7] mmc: sdhci: clear auto cmd setting bits for no data cmds

[Dong Aisheng]

The auto cmd settings bits should be cleared before sending new commands
or we may receive command timeout error for normal commands due to wrongly
pre-sent auto cmd.

e.g. we receive CMD13 timeout error due to ACMD23 is wrongly enabled
by former data commands.

mmc2: new high speed DDR MMC card at address 0001
mmcblk1: mmc2:0001 SEM08G 7.39 GiB
mmcblk1boot0: mmc2:0001 SEM08G partition 1 2.00 MiB
mmcblk1boot1: mmc2:0001 SEM08G partition 2 2.00 MiB
mmcblk1rpmb: mmc2:0001 SEM08G partition 3 128 KiB
 mmcblk1: p1 p2 p3 p4 < p5 p6 p7 >
mmc2: Timeout waiting for hardware interrupt.
 mmcblk1boot1: unknown partition table
mmc2: Timeout waiting for hardware interrupt.
 mmcblk1boot0: unknown partition table

Signed-off-by: Dong Aisheng <b29396 at freescale.com>
---
 drivers/mmc/host/sdhci.c |    5 +++++
 1 files changed, 5 insertions(+), 0 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index a21a710..f868e9b 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -898,6 +898,11 @@ static void sdhci_set_transfer_mode(struct sdhci_host *host,
 	u16 mode;
 	struct mmc_data *data = cmd->data;
 
+	/* clear Auto CMD settings for no data CMDs */
+	mode = sdhci_readw(host, SDHCI_TRANSFER_MODE);
+	sdhci_writew(host, mode & ~(SDHCI_TRNS_AUTO_CMD12 |
+			SDHCI_TRNS_AUTO_CMD23), SDHCI_TRANSFER_MODE);
+
 	if (data == NULL)
 		return;
 
-- 
1.7.2.rc3