[PATCH 11/12] usb: phy-mxs: update binding for adding disconnect line property

[Peter Chen]

On Sat, Oct 12, 2013 at 05:05:23PM +0200, Thomas Petazzoni wrote:
> Dear Peter Chen,
> 
> On Sat, 12 Oct 2013 17:09:45 +0800, Peter Chen wrote:
> > This property is used to disconnect line between USB PHY and
> > USB controller.
> > 
> > Signed-off-by: Peter Chen <peter.chen at freescale.com>
> > ---
> >  Documentation/devicetree/bindings/usb/mxs-phy.txt |    4 ++++
> >  1 files changed, 4 insertions(+), 0 deletions(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/usb/mxs-phy.txt b/Documentation/devicetree/bindings/usb/mxs-phy.txt
> > index 1a9bd85..099b0bb 100644
> > --- a/Documentation/devicetree/bindings/usb/mxs-phy.txt
> > +++ b/Documentation/devicetree/bindings/usb/mxs-phy.txt
> > @@ -5,6 +5,9 @@ Required properties:
> >  - reg: Should contain registers location and length
> >  - interrupts: Should contain phy interrupt
> >  - fsl,anatop: phandle for anatop register
> > +- disconnect_line_without_vbus: needs to disconnect
> > +connection between USB PHY and controller, it can avoid
> > +unexpected wakeup interrupt when the PHY is out of power
> >  
> >  Example:
> >  usbphy1: usbphy at 020c9000 {
> > @@ -12,4 +15,5 @@ usbphy1: usbphy at 020c9000 {
> >  	reg = <0x020c9000 0x1000>;
> >  	interrupts = <0 44 0x04>;
> >  	fsl,anatop = <&anatop>;
> > +	disconnect_line_without_vbus;
> >  };
> 
> Device Tree properties use "-" as a separator, not "_". So, it should
> be:
> 
> 	disconnect-line-without-vbus
> 
> Also, all your patches touching Device Tree bindings should be Cc'ed to
> the devicetree@ mailing list.
> 

Thanks, I will change, and cc DT ML and maintainer, thanks.

-- 

Best Regards,
Peter Chen