[PATCH v2 2/5] ARM: dts: omap: Add new bindings for OMAP

[Benoit Cousson]

Hi Rajendra,

On 09/10/2013 12:11, Rajendra Nayak wrote:
> On OMAP we have co-processor IPs, memory controllers,
> GPIOs which control regulators and power switches to
> PMIC, and SoC internal Bus IPs, some or most of which
> should either not be reset or idled or both at init.
> (In some cases there are erratas which prevent an IP
> from being reset)
> Have a way to pass this information from DT.

Did you get some acked-by from the DT maintainers?
Every new bindings must be carefully reviewed now.

Regards,
Benoit

>
> Update the am33xx/omap4 and omap5 dtsi files with the
> new bindings for modules which either should not be
> idled. reset or both. A later patch would cleanup the
> same information that exists today as part of the hwmod
> data files.
>
> Signed-off-by: Rajendra Nayak <rnayak at ti.com>
> ---
>   .../devicetree/bindings/arm/omap/omap.txt          |    3 ++-
>   arch/arm/boot/dts/am33xx.dtsi                      |    2 ++
>   arch/arm/boot/dts/omap4.dtsi                       |    3 +++
>   arch/arm/boot/dts/omap5.dtsi                       |    2 ++
>   4 files changed, 9 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/arm/omap/omap.txt b/Documentation/devicetree/bindings/arm/omap/omap.txt
> index 91b7049..808c154 100644
> --- a/Documentation/devicetree/bindings/arm/omap/omap.txt
> +++ b/Documentation/devicetree/bindings/arm/omap/omap.txt
> @@ -21,7 +21,8 @@ Required properties:
>   Optional properties:
>   - ti,no_idle_on_suspend: When present, it prevents the PM to idle the module
>     during suspend.
> -
> +- ti,no-reset-on-init: When present, the module should not be reset at init
> +- ti,no-idle-on-init: When present, the module should not be idled at init
>
>   Example:
>
> diff --git a/arch/arm/boot/dts/am33xx.dtsi b/arch/arm/boot/dts/am33xx.dtsi
> index f9c5da9..ec33ea0 100644
> --- a/arch/arm/boot/dts/am33xx.dtsi
> +++ b/arch/arm/boot/dts/am33xx.dtsi
> @@ -607,6 +607,7 @@
>   			reg = <0x44d00000 0x4000	/* M3 UMEM */
>   			       0x44d80000 0x2000>;	/* M3 DMEM */
>   			ti,hwmods = "wkup_m3";
> +			ti,no-reset-on-init;
>   		};
>
>   		elm: elm at 48080000 {
> @@ -637,6 +638,7 @@
>   		gpmc: gpmc at 50000000 {
>   			compatible = "ti,am3352-gpmc";
>   			ti,hwmods = "gpmc";
> +			ti,no-idle-on-init;
>   			reg = <0x50000000 0x2000>;
>   			interrupts = <100>;
>   			gpmc,num-cs = <7>;
> diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi
> index 22d9f2b..e8fe797 100644
> --- a/arch/arm/boot/dts/omap4.dtsi
> +++ b/arch/arm/boot/dts/omap4.dtsi
> @@ -214,6 +214,7 @@
>   			gpmc,num-cs = <8>;
>   			gpmc,num-waitpins = <4>;
>   			ti,hwmods = "gpmc";
> +			ti,no-idle-on-init;
>   		};
>
>   		uart1: serial at 4806a000 {
> @@ -492,6 +493,7 @@
>   			reg = <0x4c000000 0x100>;
>   			interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH>;
>   			ti,hwmods = "emif1";
> +			ti,no-idle-on-init;
>   			phy-type = <1>;
>   			hw-caps-read-idle-ctrl;
>   			hw-caps-ll-interface;
> @@ -503,6 +505,7 @@
>   			reg = <0x4d000000 0x100>;
>   			interrupts = <GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;
>   			ti,hwmods = "emif2";
> +			ti,no-idle-on-init;
>   			phy-type = <1>;
>   			hw-caps-read-idle-ctrl;
>   			hw-caps-ll-interface;
> diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
> index 7cdea1b..a9d49df 100644
> --- a/arch/arm/boot/dts/omap5.dtsi
> +++ b/arch/arm/boot/dts/omap5.dtsi
> @@ -607,6 +607,7 @@
>   		emif1: emif at 0x4c000000 {
>   			compatible	= "ti,emif-4d5";
>   			ti,hwmods	= "emif1";
> +			ti,no-idle-on-init;
>   			phy-type	= <2>; /* DDR PHY type: Intelli PHY */
>   			reg = <0x4c000000 0x400>;
>   			interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH>;
> @@ -618,6 +619,7 @@
>   		emif2: emif at 0x4d000000 {
>   			compatible	= "ti,emif-4d5";
>   			ti,hwmods	= "emif2";
> +			ti,no-idle-on-init;
>   			phy-type	= <2>; /* DDR PHY type: Intelli PHY */
>   			reg = <0x4d000000 0x400>;
>   			interrupts = <GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;
>