[PATCH v7 0/2] Add PCIe support for i.MX6q

[Marek Vasut]

Hi,

> On Wed, Sep 25, 2013 at 9:24 PM, Shawn Guo <shawn.guo at linaro.org> wrote:
> > Hi Bjorn,
> > 
> > This is basically a resend of imx6 pcie driver patch for inclusion into
> > PCI tree.  Since we expect you apply the patch with your SoB, I dropped
> > your ACK tag there.
> > 
> > I have to ask you to carry the first patch which adds some macros to be
> > used by pcie driver patch.  Since imx6q-iomuxc-gpr.h gets rare updates
> > recently, it should be less likely we will run into merge conflict on it.
> > 
> > Changes since v6:
> > 
> > * Drop arch bits from driver patch, and will handle arch bits through
> > 
> >   arm-soc separately.
> > 
> > * Use devm_clk_get() instead of clk_get().
> > * Drop unnecessary (val != exp_val) check in pcie_phy_poll_ack() loop.
> > * Rename function imx6_init() to imx6_pcie_init().
> > 
> > Shawn
> > 
> > Sean Cross (2):
> >   ARM: imx6q: Add PCIe bits to GPR syscon definition
> >   PCI: imx6: Add support for i.MX6 PCIe controller
> >  
> >  .../devicetree/bindings/pci/designware-pcie.txt    |    7 +-
> >  drivers/pci/host/Kconfig                           |    6 +
> >  drivers/pci/host/Makefile                          |    1 +
> >  drivers/pci/host/pci-imx6.c                        |  576
> >  ++++++++++++++++++++ include/linux/mfd/syscon/imx6q-iomuxc-gpr.h       
> >  |    8 +
> >  5 files changed, 597 insertions(+), 1 deletion(-)
> >  create mode 100644 drivers/pci/host/pci-imx6.c
> 
> I merged both of these to my pci/host-imx6 branch for v3.13.
> 
> I made a couple minor spelling and whitespace corrections.

I have MX6 hardware with a PCIe switch, so I can test that stuff. Thus far, of 
course, the switch doesn't work. Is getting the switch to work only a matter of 
programming the RdWr0 vs. RdWr1 mode into the iATU or is there something more ?

Thanks!

Best regards,
Marek Vasut