imx-drm does not report correct info in fbset

[Fabio Estevam]

On Fri, Jun 28, 2013 at 2:28 PM, Fabio Estevam <festevam at gmail.com> wrote:
> Hi Philipp/Sascha,
>
> When I enable the parallel display on a mx53qsb, I noticed that fbset
> does not report the correct information:
>
> mode "800x480-0"
>         # D: 0.000 MHz, H: 0.000 kHz, V: 0.000 Hz
>         geometry 800 480 800 480 16
>         timings 0 0 0 0 0 0 0

Ok, just realized that my host PC reports the same in the 'timings' line.

So not an issue with the imx-drm driver then.

Regards,

Fabio Estevam