[PATCH 6/8] clocksource: sun4i: Remove TIMER_SCAL variable
Maxime Ripard
maxime.ripard at free-electrons.com
Wed Jun 26 17:16:59 EDT 2013
The prescaler is only used when using the internal low frequency
oscillator (at 32kHz). Since we're using the higher frequency oscillator
at 24MHz, we can just remove it.
Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
---
drivers/clocksource/sun4i_timer.c | 10 +++-------
1 file changed, 3 insertions(+), 7 deletions(-)
diff --git a/drivers/clocksource/sun4i_timer.c b/drivers/clocksource/sun4i_timer.c
index 7f3b248..912d3e0 100644
--- a/drivers/clocksource/sun4i_timer.c
+++ b/drivers/clocksource/sun4i_timer.c
@@ -36,7 +36,6 @@
#define TIMER_INTVAL_REG(val) (0x10 * val + 0x14)
#define TIMER_CNTVAL_REG(val) (0x10 * val + 0x18)
-#define TIMER_SCAL 16
#define TIMER_CNT64_CTL_REG 0xa0
#define TIMER_CNT64_CTL_CLR BIT(0)
#define TIMER_CNT64_CTL_RL BIT(1)
@@ -141,7 +140,6 @@ static cycle_t sun4i_timer_clksrc_read(struct clocksource *c)
static void __init sun4i_timer_init(struct device_node *node)
{
- unsigned long rate = 0;
struct clk *clk;
int ret, irq;
u32 val;
@@ -159,15 +157,13 @@ static void __init sun4i_timer_init(struct device_node *node)
panic("Can't get timer clock");
clk_prepare_enable(clk);
- rate = clk_get_rate(clk);
-
writel(TIMER_CNT64_CTL_CLR, timer_base + TIMER_CNT64_CTL_REG);
setup_sched_clock(sun4i_timer_sched_read, 32, clk_get_rate(clk));
clocksource_mmio_init(timer_base + TIMER_CNT64_LOW_REG, node->name,
clk_get_rate(clk), 300, 32,
sun4i_timer_clksrc_read);
- writel(rate / (TIMER_SCAL * HZ),
+ writel(clk_get_rate(clk) / HZ,
timer_base + TIMER_INTVAL_REG(0));
/* set clock source to HOSC, 16 pre-division */
@@ -191,8 +187,8 @@ static void __init sun4i_timer_init(struct device_node *node)
sun4i_clockevent.cpumask = cpumask_of(0);
- clockevents_config_and_register(&sun4i_clockevent, rate / TIMER_SCAL,
- 0x1, 0xff);
+ clockevents_config_and_register(&sun4i_clockevent, clk_get_rate(clk),
+ 0x1, 0xffffffff);
}
CLOCKSOURCE_OF_DECLARE(sun4i, "allwinner,sun4i-timer",
sun4i_timer_init);
--
1.8.3.1
More information about the linux-arm-kernel
mailing list