[PATCH v4] irqchip: Add support for ARMv7-M's NVIC

[Thomas Gleixner]

On Tue, 25 Jun 2013, Grant Likely wrote:
> On Tue, Jun 25, 2013 at 11:34 AM, Uwe Kleine-König
> <u.kleine-koenig at pengutronix.de> wrote:
> > Hello Thomas, hello Grant,
> >
> > On Wed, Jun 12, 2013 at 11:50:35PM +0200, Uwe Kleine-König wrote:
> >> This interrupt controller is found on Cortex-M3 and Cortex-M4 machines.
> >>
> >> Support for this controller appeared in Catalin's Cortex tree based on
> >> 2.6.33 but was nearly completely rewritten.
> >>
> >> Signed-off-by: Catalin Marinas <catalin.marinas at arm.com>
> >> Signed-off-by: Uwe Kleine-König <u.kleine-koenig at pengutronix.de>
> >> ---
> >>
> >> Notes:
> >>     Changes since v3, sent with
> >>     Message-Id: <1366214540-31166-1-git-send-email-u.kleine-koenig at pengutronix.de>:
> >>
> >>      - use generic chip
> >>      - rename nvic_do_IRQ to nvic_handle_irq
> >>
> >>     This depends on the stuff currently in tip/irq/for-arm
> > I see that tip/irq/for-arm went into next via Grant's irqdomain tree. I
> > assume that means the changes go in for 3.11?
> 
> Yes, the plan is to put that branch into v3.11. I don't know if Thomas
> plans to send a separate pull request for the irq/for-arm branch, or
> if he is going to let it go as part of my pull request. I'll work it

irq/for-arm is in irq/core as well. So whoever sends first will merge
it and the later pull request will just contain the same commits.

> out with him when the merge window opens. It would probably be best
> for your patch to be applied on the irq/for-arm branch and pushed
> separately from my irqdomain branch since I don't maintain any of the
> irqchip drivers.

I can take it via tip/irq/core.

Thanks,

	tglx