[PATCH v3 6/6] ARM: davinci: da850: configure system configuration chip(CFGCHIP3) for emac
Prabhakar Lad
prabhakar.csengg at gmail.com
Sun Jun 23 11:00:07 EDT 2013
From: "Lad, Prabhakar" <prabhakar.csengg at gmail.com>
This patch makes a common function for to configure emac and calls
it appropriately in DT and non DT boot mode. The system configuration
chip CFGCHIP3, controls the emac module. This patch appropriately
configures this register for emac and sets DA850_MII_MDIO_CLKEN_PIN
GPIO pin appropriately.
Signed-off-by: Lad, Prabhakar <prabhakar.csengg at gmail.com>
Cc: linux-arm-kernel at lists.infradead.org
Cc: linux-kernel at vger.kernel.org
Cc: davinci-linux-open-source at linux.davincidsp.com
Cc: netdev at vger.kernel.org
Cc: devicetree-discuss at lists.ozlabs.org
Cc: Sekhar Nori <nsekhar at ti.com>
Cc: Heiko Schocher <hs at denx.de>
---
Changes for v2: none
Changes for v3:
a> added a common function in da850.c to configure
the CFGCHIP3 chip.
arch/arm/mach-davinci/board-da850-evm.c | 36 ++--------------------
arch/arm/mach-davinci/da850.c | 45 ++++++++++++++++++++++++++++
arch/arm/mach-davinci/da8xx-dt.c | 16 ++++++++++
arch/arm/mach-davinci/include/mach/da8xx.h | 1 +
4 files changed, 64 insertions(+), 34 deletions(-)
diff --git a/arch/arm/mach-davinci/board-da850-evm.c b/arch/arm/mach-davinci/board-da850-evm.c
index 8a24b6c..03dd1df 100644
--- a/arch/arm/mach-davinci/board-da850-evm.c
+++ b/arch/arm/mach-davinci/board-da850-evm.c
@@ -50,7 +50,6 @@
#include <media/tvp514x.h>
#include <media/adv7343.h>
-#define DA850_EVM_PHY_ID "davinci_mdio-0:00"
#define DA850_LCD_PWR_PIN GPIO_TO_PIN(2, 8)
#define DA850_LCD_BL_PIN GPIO_TO_PIN(2, 15)
@@ -60,8 +59,6 @@
#define DA850_WLAN_EN GPIO_TO_PIN(6, 9)
#define DA850_WLAN_IRQ GPIO_TO_PIN(6, 10)
-#define DA850_MII_MDIO_CLKEN_PIN GPIO_TO_PIN(2, 6)
-
static struct mtd_partition da850evm_spiflash_part[] = {
[0] = {
.name = "UBL",
@@ -1033,26 +1030,18 @@ static const short da850_evm_rmii_pins[] = {
static int __init da850_evm_config_emac(void)
{
- void __iomem *cfg_chip3_base;
- int ret;
- u32 val;
struct davinci_soc_info *soc_info = &davinci_soc_info;
u8 rmii_en = soc_info->emac_pdata->rmii_en;
+ int ret;
if (!machine_is_davinci_da850_evm())
return 0;
- cfg_chip3_base = DA8XX_SYSCFG0_VIRT(DA8XX_CFGCHIP3_REG);
-
- val = __raw_readl(cfg_chip3_base);
-
if (rmii_en) {
- val |= BIT(8);
ret = davinci_cfg_reg_list(da850_evm_rmii_pins);
pr_info("EMAC: RMII PHY configured, MII PHY will not be"
" functional\n");
} else {
- val &= ~BIT(8);
ret = davinci_cfg_reg_list(da850_evm_mii_pins);
pr_info("EMAC: MII PHY configured, RMII PHY will not be"
" functional\n");
@@ -1062,28 +1051,7 @@ static int __init da850_evm_config_emac(void)
pr_warn("%s: CPGMAC/RMII mux setup failed: %d\n",
__func__, ret);
- /* configure the CFGCHIP3 register for RMII or MII */
- __raw_writel(val, cfg_chip3_base);
-
- ret = davinci_cfg_reg(DA850_GPIO2_6);
- if (ret)
- pr_warn("%s:GPIO(2,6) mux setup failed\n", __func__);
-
- ret = gpio_request(DA850_MII_MDIO_CLKEN_PIN, "mdio_clk_en");
- if (ret) {
- pr_warn("Cannot open GPIO %d\n", DA850_MII_MDIO_CLKEN_PIN);
- return ret;
- }
-
- /* Enable/Disable MII MDIO clock */
- gpio_direction_output(DA850_MII_MDIO_CLKEN_PIN, rmii_en);
-
- soc_info->emac_pdata->phy_id = DA850_EVM_PHY_ID;
-
- ret = da8xx_register_emac();
- if (ret)
- pr_warn("%s: EMAC registration failed: %d\n", __func__, ret);
-
+ da850_config_emac(0, rmii_en);
return 0;
}
device_initcall(da850_evm_config_emac);
diff --git a/arch/arm/mach-davinci/da850.c b/arch/arm/mach-davinci/da850.c
index c43abee..d8021bb 100644
--- a/arch/arm/mach-davinci/da850.c
+++ b/arch/arm/mach-davinci/da850.c
@@ -1197,6 +1197,51 @@ no_ddrpll_mem:
return ret;
}
+void __init da850_config_emac(u32 dt_mode, u32 rmii_enabled)
+{
+#define DA850_MII_MDIO_CLKEN_PIN GPIO_TO_PIN(2, 6)
+#define DA850_EVM_PHY_ID "davinci_mdio-0:00"
+
+ void __iomem *cfg_chip3_base;
+ int ret;
+ u32 val;
+
+ cfg_chip3_base = DA8XX_SYSCFG0_VIRT(DA8XX_CFGCHIP3_REG);
+
+ val = readl(cfg_chip3_base);
+
+ if (rmii_enabled)
+ val |= BIT(8);
+ else
+ val &= ~BIT(8);
+
+ /* configure the CFGCHIP3 register for RMII or MII */
+ writel(val, cfg_chip3_base);
+
+ ret = davinci_cfg_reg(DA850_GPIO2_6);
+ if (ret)
+ pr_warn("%s:GPIO(2,6) mux setup failed\n", __func__);
+
+ ret = gpio_request(DA850_MII_MDIO_CLKEN_PIN, "mdio_clk_en");
+ if (ret) {
+ pr_warn("Cannot open GPIO %d\n", DA850_MII_MDIO_CLKEN_PIN);
+ return;
+ }
+
+ /* Enable/Disable MII MDIO clock */
+ gpio_direction_output(DA850_MII_MDIO_CLKEN_PIN, rmii_enabled);
+
+ if (!dt_mode) {
+ struct davinci_soc_info *soc_info = &davinci_soc_info;
+
+ soc_info->emac_pdata->phy_id = DA850_EVM_PHY_ID;
+ ret = da8xx_register_emac();
+ if (ret)
+ pr_warn("%s: EMAC registration failed: %d\n",
+ __func__, ret);
+ }
+}
+
/* VPIF resource, platform data */
static u64 da850_vpif_dma_mask = DMA_BIT_MASK(32);
diff --git a/arch/arm/mach-davinci/da8xx-dt.c b/arch/arm/mach-davinci/da8xx-dt.c
index 1eb3fa8..ca2443c 100644
--- a/arch/arm/mach-davinci/da8xx-dt.c
+++ b/arch/arm/mach-davinci/da8xx-dt.c
@@ -56,12 +56,28 @@ static struct of_dev_auxdata da850_auxdata_lookup[] __initdata = {
#ifdef CONFIG_ARCH_DAVINCI_DA850
+static void __init da8xx_config_emac(void)
+{
+ struct device_node *np;
+ u32 rmii_en = 0;
+
+ np = of_find_compatible_node(NULL, NULL, "ti,davinci-dm6467-emac");
+ if (!np)
+ return;
+
+ of_property_read_u32(np, "ti,davinci-rmii-en", &rmii_en);
+
+ da850_config_emac(1, rmii_en);
+}
+
+
static void __init da850_init_machine(void)
{
of_platform_populate(NULL, of_default_bus_match_table,
da850_auxdata_lookup, NULL);
da8xx_uart_clk_enable();
+ da8xx_config_emac();
}
static const char *da850_boards_compat[] __initdata = {
diff --git a/arch/arm/mach-davinci/include/mach/da8xx.h b/arch/arm/mach-davinci/include/mach/da8xx.h
index 78fae15..b01304b 100644
--- a/arch/arm/mach-davinci/include/mach/da8xx.h
+++ b/arch/arm/mach-davinci/include/mach/da8xx.h
@@ -109,6 +109,7 @@ int __init da850_register_vpif_capture
void da8xx_restart(char mode, const char *cmd);
void da8xx_rproc_reserve_cma(void);
int da8xx_register_rproc(void);
+void da850_config_emac(u32 dt_mode, u32 rmii_enabled);
extern struct platform_device da8xx_serial_device;
extern struct emac_platform_data da8xx_emac_pdata;
--
1.7.9.5
More information about the linux-arm-kernel
mailing list