[PATCH v4 00/10] ARM: Exynos: Add Exynos5420 SoC support
Tomasz Figa
t.figa at samsung.com
Tue Jun 18 05:49:38 EDT 2013
Hi Chander,
On Tuesday 18 of June 2013 11:59:12 Chander Kashyap wrote:
> Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds
> initial support for this SoC.
>
> Changes since v3:
> 1. Updated the max cpu clock frequency in dt node.
> 2. Sorted DT nodes alphabetically as suggested by Kukjin.
> 3. Removed the duplicate commit log comment in:
> "clocksource: exynos_mct: use (request/free)_irq calls for local timer
> registration"
> 4. Added comment for Exynos5440 in commit log of the patch:
> "ARM: dts: fork out common Exynos5 nodes"
>
> Changes since v2:
>
> 1. Renamed oscclk to fin_pll, in order to keep it consistent with
> Exynos4/Exynos5
> 2. Pass memory as single bank rather than splitting in 256MB size banks.
>
> Changes since v1:
>
> 1. As not-dt platforms will not be supported from 3.11 onwards, following
> patches from previous patch series are dropped:
> "irqchip: exynos-combiner: set irq base as 256 for Exynos5420"
> "ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based
> SoCs" 2. Added device type property in cpu node in the following patch:
> "ARM: dts: list the CPU nodes for Exynos5250
> 3. Sorted out the nodes listed in based upon the physical addresses as
> suggested by Tomasz Figa.
> 4. As Tomasz is going to consolidate the secondary cpu power register
> address calculation in all possible scnarios, hence dropped the following
> patch: "ARM: Exynos: fix secondary cpu power control register address
> calculation" 5. Replaced the setup/remove)_irq calls with
> (request/free)_irq calls as suggested by Mark Rutland in patch:
> "clocksource: exynos_mct: use (request/free)_irq calls for local timer
> registration"
> 6. Changed the registration of epll and rpll from pll35xx to pl36xx.
> 7. Changed driver data selection for serial port, based on ARCH_EXYNOS.
> 8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa.
>
> Chander Kashyap (10):
> ARM: dts: fork out common Exynos5 nodes
> ARM: dts: list the CPU nodes for Exynos5250
> ARM: Exynos: Add support for Exynos5420 SoC
> serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is
> defined
> ARM: Exynos: use four additional chipid bits to identify Exynos
> family
> clk: exynos5420: register clocks using common clock framework
> ARM: dts: Add initial device tree support for Exynos5420
> clocksource: exynos_mct: use (request/free)_irq calls for local timer
> registration
> ARM: Exynos: add secondary CPU boot base location for Exynos5420
> ARM: Exynos: extend soft-reset support for Exynos5420
>
> .../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++
> arch/arm/boot/dts/Makefile | 1 +
> arch/arm/boot/dts/exynos5.dtsi | 111 +++
> arch/arm/boot/dts/exynos5250.dtsi | 78 +-
> arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 +
> arch/arm/boot/dts/exynos5420.dtsi | 103 +++
> arch/arm/mach-exynos/Kconfig | 10 +
> arch/arm/mach-exynos/common.c | 18 +-
> arch/arm/mach-exynos/include/mach/uncompress.h | 7 +-
> arch/arm/mach-exynos/mach-exynos5-dt.c | 1 +
> arch/arm/mach-exynos/platsmp.c | 12 +-
> arch/arm/plat-samsung/include/plat/cpu.h | 8 +
> drivers/clk/samsung/Makefile | 1 +
> drivers/clk/samsung/clk-exynos5420.c | 762
> ++++++++++++++++++++ drivers/clocksource/exynos_mct.c |
> 35 +-
> drivers/tty/serial/samsung.c | 4 +-
> 16 files changed, 1279 insertions(+), 106 deletions(-)
> create mode 100644
> Documentation/devicetree/bindings/clock/exynos5420-clock.txt create mode
> 100644 arch/arm/boot/dts/exynos5.dtsi
> create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts
> create mode 100644 arch/arm/boot/dts/exynos5420.dtsi
> create mode 100644 drivers/clk/samsung/clk-exynos5420.c
Looks good.
Reviewed-by: Tomasz Figa <t.figa at samsung.com>
Best regards,
Tomasz
More information about the linux-arm-kernel
mailing list