[PATCH v3 00/10] ARM: Exynos: Add Exynos5420 SoC support
Chander Kashyap
chander.kashyap at linaro.org
Tue Jun 18 00:28:08 EDT 2013
On 17 June 2013 17:26, Kukjin Kim <kgene.kim at samsung.com> wrote:
> Chander Kashyap wrote:
>>
>> Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds
>> initial support for this SoC.
>> Changes since v2:
>>
>> 1. Renamed oscclk to fin_pll, in order to keep it consistant with
>> Exynos4/Exynos5
>> 2. Pass memory as single bank rather than splitting in 256MB size banks.
>>
>> Changes since v1:
>>
>> 1. As not-dt platforms will not be supported from 3.11 onwards, following
>> patches from previous patch series are dropped:
>> "irqchip: exynos-combiner: set irq base as 256 for Exynos5420"
>> "ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based
>> SoCs"
>> 2. Added device type property in cpu node in the following patch:
>> "ARM: dts: list the CPU nodes for Exynos5250
>> 3. Sorted out the nodes listed in based upon the physical addresses as
>> suggested
>> by Tomasz Figa.
>> 4. As Tomasz is going to consolidate the secondary cpu power register
>> address
>> calculation in all possible scnarios, hence dropped the following
> patch:
>> "ARM: Exynos: fix secondary cpu power control register address
>> calculation"
>> 5. Replaced the setup/remove)_irq calls with (request/free)_irq calls as
>> suggested by Mark Rutland in patch:
>> "clocksource: exynos_mct: use (request/free)_irq calls for local timer
>> registration"
>> 6. Changed the registration of epll and rpll from pll35xx to pl36xx.
>> 7. Changed driver data selection for serial port, based on ARCH_EXYNOS.
>> 8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa.
>>
>> Chander Kashyap (10):
>> ARM: dts: fork out common Exynos5 nodes
>> ARM: dts: list the CPU nodes for Exynos5250
>> ARM: Exynos: Add support for Exynos5420 SoC
>> serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is
>> defined
>> ARM: Exynos: use four additional chipid bits to identify Exynos
>> family
>> clk: exynos5420: register clocks using common clock framework
>> ARM: dts: Add initial device tree support for Exynos5420
>> clocksource: exynos_mct: use (request/free)_irq calls for local timer
>> registration
>> ARM: Exynos: add secondary CPU boot base location for Exynos5420
>> ARM: Exynos: extend soft-reset support for Exynos5420
>>
>> .../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++
>> arch/arm/boot/dts/Makefile | 1 +
>> arch/arm/boot/dts/exynos5.dtsi | 111 +++
>> arch/arm/boot/dts/exynos5250.dtsi | 80 +-
>> arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 +
>> arch/arm/boot/dts/exynos5420.dtsi | 103 +++
>> arch/arm/mach-exynos/Kconfig | 10 +
>> arch/arm/mach-exynos/common.c | 18 +-
>> arch/arm/mach-exynos/include/mach/uncompress.h | 7 +-
>> arch/arm/mach-exynos/mach-exynos5-dt.c | 1 +
>> arch/arm/mach-exynos/platsmp.c | 12 +-
>> arch/arm/plat-samsung/include/plat/cpu.h | 8 +
>> drivers/clk/samsung/Makefile | 1 +
>> drivers/clk/samsung/clk-exynos5420.c | 762
>> ++++++++++++++++++++
>> drivers/clocksource/exynos_mct.c | 35 +-
>> drivers/tty/serial/samsung.c | 4 +-
>> 16 files changed, 1280 insertions(+), 107 deletions(-)
>> create mode 100644 Documentation/devicetree/bindings/clock/exynos5420-
>> clock.txt
>> create mode 100644 arch/arm/boot/dts/exynos5.dtsi
>> create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts
>> create mode 100644 arch/arm/boot/dts/exynos5420.dtsi
>> create mode 100644 drivers/clk/samsung/clk-exynos5420.c
>>
>> --
>> 1.7.9.5
>
> Chander, basically looks good to me but there are some comments on several
> patches.
Thanks Kukjin.
>
> Please address comments then, let me take this series after getting Mike's
> ack on clock stuff.
I will address the comments and resend.
>
> Thanks,
> - Kukjin
>
--
with warm regards,
Chander Kashyap
More information about the linux-arm-kernel
mailing list