[PATCH 0/7] genirq: add irq_get_trigger_type() to get IRQ flags

Grant Likely grant.likely at linaro.org
Mon Jun 17 18:29:15 EDT 2013


On Fri, Jun 14, 2013 at 5:40 PM, Javier Martinez Canillas
<javier.martinez at collabora.co.uk> wrote:
> Drivers that want to get the trigger edge/level type flags for a
> given interrupt have to first call irq_get_irq_data(irq) to get
> the struct irq_data and then irqd_get_trigger_type(irq_data) to
> obtain the IRQ flags.
>
> This is not only error prone but also unnecessary exposes the
> struct irq_data to callers. This patch-set adds a new function
> irq_get_trigger_type() to obtain the edge/level flags for an IRQ
> and updates the places where irq_get_irq_data(irq) was called
> just to obtain the flags from the struct irq_data.
>
> The patch-set is composed of the following patches:
>
> [PATCH 1/7] genirq: add irq_get_trigger_type() to get IRQ flags
> [PATCH 2/7] gpio: mvebu: use irq_get_trigger_type() to get IRQ flags
> [PATCH 3/7] mfd: twl4030-irq: use irq_get_trigger_type() to get IRQ flags
> [PATCH 4/7] mfd: stmpe: use irq_get_trigger_type() to get IRQ flags
> [PATCH 5/7] arm: orion: use irq_get_trigger_type() to get IRQ flags
> [PATCH 6/7] MIPS: octeon: use irq_get_trigger_type() to get IRQ flags
> [PATCH 7/7] irqdomain: use irq_get_trigger_type() to get IRQ flags

For the whole series:
Acked-by: Grant Likely <grant.likely at linaro.org>

>
>  arch/arm/plat-orion/gpio.c           |    2 +-
>  arch/mips/cavium-octeon/octeon-irq.c |    2 +-
>  drivers/gpio/gpio-mvebu.c            |    2 +-
>  drivers/mfd/stmpe.c                  |    3 +--
>  drivers/mfd/twl4030-irq.c            |    5 +----
>  include/linux/irq.h                  |    6 ++++++
>  kernel/irq/irqdomain.c               |    2 +-
>  7 files changed, 12 insertions(+), 10 deletions(-)
>
> Best regards,
> Javier



More information about the linux-arm-kernel mailing list