[PATCH 2/7] gpio: mvebu: use irq_get_trigger_type() to get IRQ flags

Javier Martinez Canillas javier.martinez at collabora.co.uk
Fri Jun 14 12:40:44 EDT 2013


Use irq_get_trigger_type() to get the IRQ trigger type flags
instead calling irqd_get_trigger_type(irq_get_irq_data(irq))

Signed-off-by: Javier Martinez Canillas <javier.martinez at collabora.co.uk>
---
 drivers/gpio/gpio-mvebu.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/gpio/gpio-mvebu.c b/drivers/gpio/gpio-mvebu.c
index 3a4816a..80ad35e 100644
--- a/drivers/gpio/gpio-mvebu.c
+++ b/drivers/gpio/gpio-mvebu.c
@@ -457,7 +457,7 @@ static void mvebu_gpio_irq_handler(unsigned int irq, struct irq_desc *desc)
 		if (!(cause & (1 << i)))
 			continue;
 
-		type = irqd_get_trigger_type(irq_get_irq_data(irq));
+		type = irq_get_trigger_type(irq);
 		if ((type & IRQ_TYPE_SENSE_MASK) == IRQ_TYPE_EDGE_BOTH) {
 			/* Swap polarity (race with GPIO line) */
 			u32 polarity;
-- 
1.7.7.6




More information about the linux-arm-kernel mailing list