[RFC PATCH 1/4] arm: omap: Add phy binding info for musb in plat data

Tony Lindgren tony at atomide.com
Fri Jun 14 01:47:20 EDT 2013


* Kishon Vijay Abraham I <kishon at ti.com> [130613 22:41]:
> Hi,
> 
> On Thursday 13 June 2013 06:35 PM, Tomi Valkeinen wrote:
> >Hi,
> >
> >On 28/05/13 08:18, Kishon Vijay Abraham I wrote:
> >>Hi Tony,
> >>
> >>On Friday 17 May 2013 06:52 PM, Kishon Vijay Abraham I wrote:
> >>>In order for controllers to get PHY in case of non dt boot, the phy
> >>>binding information (phy label) should be added in the platform
> >>>data of the controller.
> >>
> >>This series would be needed to get MUSB working in OMAP3 boards for
> >>non-dt boot case. Do you think this is good enough to go in this rc cycle?
> >
> >Did this or some other solution go forward? I'm still unable to boot
> >with usb-gadget-ethernet with v3.10-rc5.
> 
> No. I think Tony is ok to take this only during next merge window.

Yes I'll apply them to omap-for-v3.11/fixes-non-critical. We really
should have basic functionaly tested and working always before the
merge window so we only need to do minimal fixes during the -rc cycle.

Regards,

Tony



More information about the linux-arm-kernel mailing list