[PATCH 13/14] ARM: AM33XX: hwmod data: irq, dma and addr info clean up

[Kevin Hilman]

Hi Vaibhav,

"Hiremath, Vaibhav" <hvaibhav at ti.com> writes:

[...]

> Paul/Kevin/Santosh,
>
> AM335x is booting up from Mainline, starting from v3.7, that’s where HWMOD data got merged to
> Mainline.
>
> We have discussed on this in the past as well, let me explain the issue here in detail
> again for everybody -

Thanks for the detail.

In my case, after more debug, it appears that where I was putting the
DTB in memory from u-boot was not working.   Using the addresses you
used gets things working again.  Thanks.

u-boot mainline (v2013.04) for BeagleBone has defaults that don't work
appear together:

U-Boot# printenv loadaddr
loadaddr=0x80200000
U-Boot# printenv fdtaddr
fdtaddr=0x80F80000

Changing fdtaddr around got things working again.  It's probably a good
idea to change the u-boot defaults to values that work, since that's a
likely starting point for people.

I'm now back to mainline booting well on both my original BeagleBone and
my BeagleBone black.

Thanks,

Kevin

> In case of Am335x we have only two possible options, as AM335x only boots up
> With DTB (Tested in BBB) -
>
> 1. Mainline u-boot + mainline Kernel:
> =====================================
>
> 1.a. Appended DTB method
> ------------------------
>
> Here you __must__ enabled below config options in order to get kernel booting,
>
> CONFIG_ARM_APPENDED_DTB=y
> CONFIG_ARM_ATAG_DTB_COMPAT=y
> CONFIG_ARM_ATAG_DTB_COMPAT_CMDLINE_FROM_BOOTLOADER=y
>
> And, I have used below command to append DTB to kernel image
>
> # cat arch/arm/boot/zImage arch/arm/boot/dts/am335x-bone.dtb >
> zImage-append && mkimage -A arm -O linux -T kernel -C none -a
> 0x80008000 -e 0x80008000 -n "Linux" -d zImage-append uImage-append
>
>
> I have attached complete log here with this mail for reference
> http://pastebin.com/82duFh78
>
>
> 1.b. Discrete DTB and uImage method:
> ------------------------------------
>
> Here you don’t need to enable any extra config options. Plain omap2plus_defconfig
> Should work without any issues.
>
> I have attached complete log here with this mail for reference
> http://pastebin.com/Nqr0PiwW
>
>
> 2. Older U-Boot (without DTB) + Mainline Kernel:
> ================================================
>
> This is same as #OPTION-1.a above.
>
>
> Thanks,
> Vaibhav