[PATCH 0/2] ARM dts: bcm281xx: use preprocessor for device trees

Olof Johansson olof at lixom.net
Tue Jun 11 03:03:44 EDT 2013

On Thu, Jun 06, 2013 at 01:41:33AM -0400, Matt Porter wrote:
> This series follows the same approach as taken on Tegra and
> OMAP DT files to use the C preprocessor in order to improve
> readability. Since bcm281xx does not yet have gpio and pinctrl
> support, this series just enables the C preprocessor and removes
> the magic constants from existing irq properties. Any new
> additions can come in using human readable definitions.
> The resulting dtb was diff-tested to validate it versus the non
> preprocessed dts version.
> Matt Porter (2):
>   ARM: dts: bcm281xx: use #include for device tree files
>   ARM: dts: bcm281xx: use existing defines for irqs

Acked-by: Olof Johansson <olof at lixom.net>

Not sure what else you'll have for 3.11 devicetree-wise, Christian -- your
choice if you want to send a pull request or ack these and we'll apply them


More information about the linux-arm-kernel mailing list