[RFC PATCH v2 2/2] drivers: mfd: vexpress: add Serial Power Controller (SPC) support

[Nicolas Pitre]

On Wed, 5 Jun 2013, Lorenzo Pieralisi wrote:

> The TC2 versatile express core tile integrates a logic block that provides the
> interface between the dual cluster test-chip and the M3 microcontroller that
> carries out power management. The logic block, called Serial Power Controller
> (SPC), contains several memory mapped registers to control among other things
> low-power states, operating points and reset control.
> 
> This patch provides a driver that enables run-time control of features
> implemented by the SPC control logic.
> 
> The driver also provides a bridge interface through the vexpress config
> infrastructure. Operations allowing to read/write operating points are
> made to go via the same interface as configuration transactions so that
> all requests to M3 are serialized.
> 
> Device tree bindings documentation for the SPC component is provided with
> the patchset.
> 

[...]

> +/*
> + * Versatile Express Serial Power Controller (SPC) support
> + *
> + * Copyright (C) 2013 ARM Ltd.
> + *
> + * Author(s): Sudeep KarkadaNagesha <sudeep.karkadanagesha at arm.com>
> + *            Achin Gupta           <achin.gupta at arm.com>
> + *            Lorenzo Pieralisi     <lorenzo.pieralisi at arm.com>

I imagine "author(s)" can be written as "authors" without a doubt.  :-)

> +EXPORT_SYMBOL_GPL(vexpress_spc_write_resume_reg);
> +EXPORT_SYMBOL_GPL(vexpress_spc_set_global_wakeup_intr);
> +EXPORT_SYMBOL_GPL(vexpress_spc_set_cpu_wakeup_irq);
> +EXPORT_SYMBOL_GPL(vexpress_spc_powerdown_enable);

I don't think anything that could possibly be made into modules should 
ever have a need for those particular calls.  So I'd suggest not 
exporting them.

Other than that, you may add...

Reviewed-by: Nicolas Pitre <nico at linaro.org>


Nicolas