[PATCH v2 0/4] ARM: dts: AM3XXX: Use preprocessor for device trees

[Benoit Cousson]

+ Afzal,

Hi Vaibhav and Afzal,

Can someone test this series before I pull it. I still don't have any AM
board to do it myself :-(

In theory, it should be fine since Florian already checked the diff, but
just in case.

Thanks,
Benoit


On 06/03/2013 04:12 PM, Florian Vaussard wrote:
> Hello,
> 
> Following my series for OMAP2+, this series makes use of the C preprocessor
> when compiling AM3xxx DT files, and accomplishes some improvements to improve
> overall readability.
> 
> The .dtb files were diff-tested before and after applying the series to
> guarantee identity for all targets.
> 
> To enable pullup/down on the pad, the bit should be cleared on AM33xx, where
> it should be set on OMAP3. This was wrong in my first version.
> 
> This series is based on Benoit's 'for_3.11/dts' branch.
> 
> Regards,
> 
> Florian
> 
> From v2:
> - Rebased on Benoit's 'for_3.11/dts'
> - Fixed inversed bit to enable pullups ('1' on OMAP, but '0' on AM33xx)
> 
> Florian Vaussard (4):
>   ARM: dts: AM3XXX: Use #include for all device trees
>   ARM: dts: AM33XX: Use existing constants for GPIOs
>   ARM: dts: AM33XX: Specific pinctrl header
>   ARM: dts: AM33XX: Use pinctrl constants
> 
>  arch/arm/boot/dts/am335x-bone.dts       |   28 ++++++------
>  arch/arm/boot/dts/am335x-evm.dts        |   76 +++++++++++++++---------------
>  arch/arm/boot/dts/am335x-evmsk.dts      |   46 +++++++++---------
>  arch/arm/boot/dts/am33xx.dtsi           |    5 ++-
>  arch/arm/boot/dts/am3517-evm.dts        |    2 +-
>  arch/arm/boot/dts/am3517_mt_ventoux.dts |    2 +-
>  include/dt-bindings/pinctrl/am33xx.h    |   37 +++++++++++++++
>  7 files changed, 118 insertions(+), 78 deletions(-)
>  create mode 100644 include/dt-bindings/pinctrl/am33xx.h
>