[PATCH 06/12] msm: iommu: Use clk_set_rate() instead of clk_set_min_rate()

[Stephen Boyd]

Calling clk_set_min_rate() is no better than just calling
clk_set_rate() because MSM clock code already takes care of
calling the min_rate ops if the clock really needs
clk_set_min_rate() called on it.

Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
---
 drivers/iommu/msm_iommu_dev.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/drivers/iommu/msm_iommu_dev.c b/drivers/iommu/msm_iommu_dev.c
index d344f6a..9144a6b 100644
--- a/drivers/iommu/msm_iommu_dev.c
+++ b/drivers/iommu/msm_iommu_dev.c
@@ -29,7 +29,6 @@
 
 #include <mach/iommu_hw-8xxx.h>
 #include <mach/iommu.h>
-#include <mach/clk.h>
 
 struct iommu_ctx_iter_data {
 	/* input */
@@ -168,7 +167,7 @@ static int msm_iommu_probe(struct platform_device *pdev)
 
 	if (!IS_ERR(iommu_clk))	{
 		if (clk_get_rate(iommu_clk) == 0)
-			clk_set_min_rate(iommu_clk, 1);
+			clk_set_rate(iommu_clk, 1);
 
 		ret = clk_prepare_enable(iommu_clk);
 		if (ret) {
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation