[PATCH] ARM: avoid mis-detecting some V7 cores in the decompressor

[Stephen Boyd]

Resending due to rmk's vacation.

On 05/24/13 15:05, Stephen Boyd wrote:
> I've noticed another problem now that our caches are used. On MSM
> we have TEXT_OFFSET set to at least 0x208000 if we've built-in
> support for MSM8x60/8960. If I boot a kernel with the MSM code
> built-in that requires the higher text offset, but I load my
> compressed kernel below that address (such as 0x0) the
> decompression fails.
>
> This happens because the page tables are written into the
> compressed data region before we relocate ourself to a higher
> location.
>
> Here's some ascii art to show the problem
>
> We start off at 0x0
>
>  0x000000 +---------+
>           |         |
>           | zImage  |
>  0x208000 |---------| <- r4 (zreladdr)
>           | zImage  |
>  0x300000 +---------+ <- _edata
>
> Then we run far enough to call cache_on which goes ahead and
> calls __setup_mmu and sets up our page tables.
>
>  0x008000 +---------+
>           |         |
>           | zImage  |
>           |         |
>  0x204000 |---------|
>           |  pgdir  |
>  0x208000 |---------| <- r4 (zreladdr)
>           |         |
>           | zImage  |
>           |         |
>  0x300000 +---------+ <- _edata
>
> This is bad because we just wrote our page tables into the
> compressed data. Nobody notices though and we finish relocating
> ourselves and then we call decompress_kernel() which fails
> randomly. (BTW, why does error() sit in a while loop forever? We
> can't get any information about why the decompression failed if
> we have debug_ll enabled. I had to patch the error() routine to
> not while loop forever to get that print after do_decompress to
> be useful.)
>
> I see a few solutions.
>
>  1) Relocate with caches off and then turn on caches after we're
>     running in a location where we won't overwrite ourselves.
>
>  2) Have temporary page tables for the relocation phase that live
>     just below the location we're going to relocate to.
>
>  3) Force bootloaders loading these types of images to load the
>     zImage at least as high as the TEXT_OFFSET is compiled to.
>
> I don't think we can convince everyone that #3 is ok to do. I'm
> leaning towards #2 since we get all the benefits of the cache
> during the relocation phase but #1 is the obviously simple fix.
>
-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation