[PATCH 4/4] ARM: sun6i: Enable clock support in the DTSI

[Emilio López]

Hi,

El 31/07/13 05:11, kevin.z.m escribió:
> Hi, Maxime,
>  
>> The problem is a bit more complex than that.
>  
>> On the A31, the losc clock is actually a mux between an external
>> oscillator running at 32kHz, and the internal oscillator running at
>> 667MHz, that would be scaled down.
>  
>> Support for this mux is not quite there yet, since I've not seen any
>> documentation for it, but this would allow to just rearrange losc
>> parents and compatible when we will had such support.
>  
> I think there is some misunderstanding. All allwinner's platforms have
> 2 losc clock source. One is the external 32KHz oscillator, and the other
> is internal 32kHz R/C circuit. The internal 32k R/C circuit can't provide
> a very exact clock on 32KHz. The mux is just for select external osc or
> internal
> 32KHz R/C. If there is no external 32kHz oscillator, we can replace it with
> internal 32kHz R/C for some low speed but not exact clock requirement.

Thanks for the clarification :)

(snip)

>> > + ahb1_mux: ahb1_mux at 01c20054 {
>> > + #clock-cells = <0>;
>> > + compatible = "allwinner,sun6i-ahb1-mux-clk";
>> > + reg = <0x01c20054 0x4>;
>> > + clocks = <&osc32k>, <&osc24M>, <&axi>, <&pll6>;
>> > + };
>> > +
>> > + ahb1: ahb1 at 01c20054 {
>> > + #clock-cells = <0>;
>> > + compatible = "allwinner,sun4i-ahb-clk";
>> > + reg = <0x01c20054 0x4>;
>> > + clocks = <&ahb1_mux>;
>> > + };
>> 
>> Depending on when this lands, I believe these two above could be merged
>> into one with the refactoring introduced on my patchset.
>  
> Since your patchset is still in RFC and we had no comments from Mike so
> far, while this one looks pretty similar to the one we had before, I
> guess the safest thing to do would be to rebase your patches on top of
> this ones.

Ok, I'll do that.

Cheers,

Emilio