[PATCH] ARM: socfpga: dts: Add support for SD/MMC

Dinh Nguyen dinguyen at altera.com
Fri Jul 26 17:22:20 EDT 2013


On Fri, 2013-07-26 at 15:13 -0600, Stephen Warren wrote:
> On 07/26/2013 02:44 PM, Dinh Nguyen wrote:
> > On Fri, 2013-07-26 at 14:02 -0600, Stephen Warren wrote:
> >> On 07/26/2013 01:33 PM, Dinh Nguyen wrote:
> >>> On Fri, 2013-07-26 at 11:24 -0600, Stephen Warren wrote:
> >>>> On 07/25/2013 04:04 PM, dinguyen at altera.com wrote:
> >>>>> From: Dinh Nguyen <dinguyen at altera.com>
> >>>>>
> >>>>> Add bindings for SD/MMC for SOCFPGA.
> >>>>> Add "syscon" to the "altr,sys-mgr" binding.
> >>
> >>>>> diff --git a/Documentation/devicetree/bindings/mmc/socfpga-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/socfpga-dw-mshc.txt
> >>
> >>>>> +Example:
> >>>>> +
> >>>>> +  The MSHC controller node can be split into two portions, SoC specific and
> >>>>> +  board specific portions, as listed below.
> >>>>
> >>>> That doesn't sound like a good idea. There should be one DT node for
> >>>> each logical block. The internal construction of the Linux drivers
> >>>> (presumably you have entirely separate code to handle the two nodes in
> >>>> Linux so far?) should not influence the DT construction at all.
> >>>
> >>> In the end, there is only 1 DT node for each logical block:
> >>
> >> Oh right, I see you were intending to show the distinction between the
> >> SoC .dtsi and board .dts file. I hadn't realized that. I don't think
> >> it's common to do that in the examples, so I would recommend just
> >> merging the whole example together myself.
> > 
> > I'll merge it.
> > 
> >>
> >>> dwmmc0 at ff704000 {
> >>> 	compatible = "altr,socfpga-dw-mshc";
> >>
> >> That should include the baseline synopsis compatible value too.
> > 
> > We don't need the baseline synopsis compatible because of
> > dw_mci_pltfm_register() call.
> 
> It's not a matter of whether it's strictly necessary for the SW to work
> right now. The compatible property should include entries for everything
> that the HW is actually compatible with.

Ah ok..will add the baseline compatible binding. But this also sounds
like there's clean-up work that can be done that I have already
_promised_ Pawell I would do for the next cycle. Along with finding
common attributes for the clocks, I think we can also move all the
platform compatible entries into a single of_device_id struct.

Dinh

> 
> Of course, if a plain driver for the raw synopsis controller/binding
> wouldn't actually work on this HW at all, without explicit knowledge of
> the extra details of the more HW-specific binding, then that's a good
> argument for leaving it out of compatible.
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
> 






More information about the linux-arm-kernel mailing list