Enabling USBH1 on mx53qsb

[Fabio Estevam]

Hi Peter,

On Thu, Jul 25, 2013 at 12:13 AM, Peter Chen <peter.chen at freescale.com> wrote:

> Would you enable CONFIG_USB_DEBUG to see where is the problem?

This is what I get:

ci_hdrc ci_hdrc.0: ChipIdea HDRC found, lpm: 0; cap: f5780100 op: f5780140
ci_hdrc ci_hdrc.0: doesn't support gadget
ci_hdrc ci_hdrc.0: EHCI Host Controller
ci_hdrc ci_hdrc.0: new USB bus registered, assigned bus number 1
ci_hdrc ci_hdrc.0: USB 2.0 started, EHCI 1.00
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
ci_hdrc ci_hdrc.1: ChipIdea HDRC found, lpm: 0; cap: f5780300 op: f5780340
ci_hdrc ci_hdrc.1: doesn't support gadget
ci_hdrc ci_hdrc.1: EHCI Host Controller
ci_hdrc ci_hdrc.1: new USB bus registered, assigned bus number 2
ci_hdrc ci_hdrc.1: USB 2.0 started, EHCI 1.00
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected

>
>>
>> However, if I access USBH1 within U-boot prior to launching the
>> kernel, then I am able to use USBH1 in the kernel succesfully.
>
> access host 1 at u-boot, what do you mean, only register access
> or let host 1 work?

This is what I do in U-boot:

MX53LOCO U-Boot > usb reset
(Re)start USB...
USB0:   USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
       scanning usb for ethernet devices... 0 Ethernet Device(s) found
MX53LOCO U-Boot > run bootcmd

Then kernel is launched and I can use USBH1 succesfully.

Regards,

Fabio Estevam