[PATCH v3 00/13] ARM: dts: Add camera and magnetometer support for TRATS(2) board

[Sylwester Nawrocki]

On 07/24/2013 03:00 PM, Kukjin Kim wrote:
> Sylwester Nawrocki wrote:
>>
>> This patch series includes some fixes and extensions to the Exynos dts
>> files to add the camera and magnetometer sensor support for the TRATS
>> and TRATS2 board. It depends on a patch from Tomasz adding initial
>> TRATS2 board dts file [1].
>>
> Already it is in my tree :)

Great, I guess some time is needed until it shows up in the public
git tree.

>> Comparing to the previous version of this patch set I've added a few
>> more patches, for the Exynos4210 based TRATS board and a patch adding
>> MIPI CSIS/DSIM PHY provider nodes and related properties to the PHY
>> consumer nodes.
>>
>> This series has been tested with the S5K6A3/FIMC-IS and S5K5BAFX
>> (front facing) cameras on top of next-20130627 tag. It can be found
>> also at:
>> http://git.linuxtv.org/snawrocki/samsung.git/next-20130627-dts-trats-v3
>>
>> Detailed changes since v2 are listed in each patch.
>>
>> Changes since v1:
>>  - enabled pull down in cam-port-{a, b}-clk-idle nodes (1/8)
>>  - added node alias for i2c-gpio at 0 I2C controller node (7/8).
>>
>> [1] http://www.spinics.net/lists/arm-kernel/msg253184.html
>>
>> Andrzej Hajda (2):
>>   ARM: dts: Add Exynos4210 SoC camera port pinctrl nodes
>>   ARM: dts: Add S5K5BA sensor regulator definitions for Trats board
>>
>> Jacek Anaszewski (1):
>>   ARM: dts: Add AK8975 device node for Exynos4412 TRATS2 board
>>
>> Sylwester Nawrocki (10):
>>   ARM: dts: Correct camera pinctrl nodes for Exynos4x12 SoCs
>>   ARM: dts: Add pinctrl entries for Exynos4x12 FIMC-IS peripherals
>>   ARM: dts: Add ISP power domain node for Exynos4x12
>>   ARM: dts: Use generic DMA bindings for Exynos4 SPI devices
>>   ARM: dts: Add camera subsystem device nodes to exynos4.dtsi
>>   ARM: dts: Add camera subsystem nodes to exynos4x12.dtsi
>>   ARM: dts: Add camera device nodes for Exynos4412 TRATS2 board
>>   ARM: dts: Add camera device nodes for Exynos4210 SoCs
>>   ARM: dts: Add FIMC nodes for Exynos4210 Trats board
>>   ARM: dts: Add MIPI PHY node to exynos4.dtsi
>>
>>  arch/arm/boot/dts/exynos4.dtsi            |  102
> ++++++++++++++++++++++++--
>>  arch/arm/boot/dts/exynos4210-pinctrl.dtsi |   23 ++++++
>>  arch/arm/boot/dts/exynos4210-trats.dts    |  103
> ++++++++++++++++++++++---
>> --
>>  arch/arm/boot/dts/exynos4210.dtsi         |   30 ++++++++
>>  arch/arm/boot/dts/exynos4412-trats2.dts   |  110
>> +++++++++++++++++++++++++++++
>>  arch/arm/boot/dts/exynos4x12-pinctrl.dtsi |   61 ++++++++++++++--
>>  arch/arm/boot/dts/exynos4x12.dtsi         |  103
> +++++++++++++++++++++++++++
>>  7 files changed, 503 insertions(+), 29 deletions(-)
>>
>> --
>> 1.7.9.5
> 
> Basically, I'm fine on this series but you said, you will address comments
> on some patches :)

Thanks, I've just sent an updated series. Would be good to finally
merge it if it looks OK. I have a few more patches on top of it but
that likely could be merged only in a week or two, after related
driver changes are finally reviewed and queued for 3.12.

--
Thanks,
Sylwester