[PATCH 5/9] ARM: dts: omap5-uevm: update LDO3 voltage to 1.5V and settings

[Nishanth Menon]

commit e00c27ef3b4c23e39d0a77b7c8e5be44c28001c7
(ARM: dts: OMAP5: Add Palmas MFD node and regulator nodes)
introduced regulator entries for OMAP5uEVM.

However, The regulator information is based on an older temporary
pre-production board variant and does not reflect production board
750-2628-XXX boards.

LDO3 supplies Low Latency Interface(LLI) hardware module which is a
special hardware to communicate with Modem. However since uEVM is
not setup by default for this communication, this should be disabled
by default.

Further, vdda_lli is supposed to be 1.5V and not 3V.

Reported-by: Marc Jüttner <m-juettner at ti.com>
Signed-off-by: Nishanth Menon <nm at ti.com>
---
 arch/arm/boot/dts/omap5-uevm.dts |    7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
index a55f4d8..c6d560b 100644
--- a/arch/arm/boot/dts/omap5-uevm.dts
+++ b/arch/arm/boot/dts/omap5-uevm.dts
@@ -362,10 +362,11 @@
 				ldo3_reg: ldo3 {
 					/* VDDAPHY_MDM: vdda_lli */
 					regulator-name = "ldo3";
-					regulator-min-microvolt = <3000000>;
-					regulator-max-microvolt = <3000000>;
-					regulator-always-on;
+					regulator-min-microvolt = <1500000>;
+					regulator-max-microvolt = <1500000>;
 					regulator-boot-on;
+					/* Only if Modem is used */
+					status = "disabled";
 				};
 
 				ldo4_reg: ldo4 {
-- 
1.7.9.5