[PATCH 1/3] serial: mxs: remove the unused macro

[Uwe Kleine-König]

Hello,

On Mon, Jul 15, 2013 at 11:08:54AM +0800, Huang Shijie wrote:
> The MXS_AUART_DMA_CONFIG is originally used to check if the DT node
> is configured with the DMA property.
> 
> But now, the MXS_AUART_DMA_CONFIG is not used any more.
> Just remove it.
> 
> Signed-off-by: Huang Shijie <b32955 at freescale.com>
> ---
>  drivers/tty/serial/mxs-auart.c |    5 +----
>  1 files changed, 1 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/tty/serial/mxs-auart.c b/drivers/tty/serial/mxs-auart.c
> index 4f5f161..465ef0b 100644
> --- a/drivers/tty/serial/mxs-auart.c
> +++ b/drivers/tty/serial/mxs-auart.c
> @@ -134,7 +134,6 @@ enum mxs_auart_type {
>  struct mxs_auart_port {
>  	struct uart_port port;
>  
> -#define MXS_AUART_DMA_CONFIG	0x1
>  #define MXS_AUART_DMA_ENABLED	0x2
>  #define MXS_AUART_DMA_TX_SYNC	2  /* bit 2 */
>  #define MXS_AUART_DMA_RX_READY	3  /* bit 3 */
> @@ -640,7 +639,7 @@ static void mxs_auart_settermios(struct uart_port *u,
>  		 * we can only implement the DMA support for auart
>  		 * in mx28.
>  		 */
> -		if (is_imx28_auart(s) && (s->flags & MXS_AUART_DMA_CONFIG)) {
> +		if (is_imx28_auart(s)) {
>  			if (!mxs_auart_dma_init(s))
>  				/* enable DMA tranfer */
>  				ctrl2 |= AUART_CTRL2_TXDMAE | AUART_CTRL2_RXDMAE
> @@ -1002,8 +1001,6 @@ static int serial_mxs_probe_dt(struct mxs_auart_port *s,
>  	}
>  	s->port.line = ret;
>  
> -	s->flags |= MXS_AUART_DMA_CONFIG;
> -
You're suggesting that MXS_AUART_DMA_CONFIG was set here unconditionally
before and so the check in the hunk above is not necessary anymore.
(<pedantic>So your "not used any more" is technically wrong.</pedantic>)

However serial_mxs_probe_dt returns earlier if the device was not probed
by dt (which I think we can assume to not apply, still it should be
mentioned in the commit log).

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |