[PATCH 1/5] iio: at91: use adc_clk_khz to make the calculation not easy to large than u32.
Josh Wu
josh.wu at atmel.com
Sun Jul 14 04:04:25 EDT 2013
for example, if adc_clk is 20Mhz and start-up time set as larger than 215us.
then the calculation "st->startup_time * adc_clk_khz" will out of u32.
In this patch, it will use khz unit for adc_clk, that avoids above problem.
Signed-off-by: Josh Wu <josh.wu at atmel.com>
---
drivers/iio/adc/at91_adc.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/iio/adc/at91_adc.c b/drivers/iio/adc/at91_adc.c
index e5b88d5..18bd54f 100644
--- a/drivers/iio/adc/at91_adc.c
+++ b/drivers/iio/adc/at91_adc.c
@@ -582,7 +582,7 @@ static const struct iio_info at91_adc_info = {
static int at91_adc_probe(struct platform_device *pdev)
{
- unsigned int prsc, mstrclk, ticks, adc_clk, shtim;
+ unsigned int prsc, mstrclk, ticks, adc_clk, adc_clk_khz, shtim;
int ret;
struct iio_dev *idev;
struct at91_adc_state *st;
@@ -680,6 +680,7 @@ static int at91_adc_probe(struct platform_device *pdev)
*/
mstrclk = clk_get_rate(st->clk);
adc_clk = clk_get_rate(st->adc_clk);
+ adc_clk_khz = adc_clk / 1000;
prsc = (mstrclk / (2 * adc_clk)) - 1;
if (!st->startup_time) {
@@ -693,15 +694,15 @@ static int at91_adc_probe(struct platform_device *pdev)
* defined in the electrical characteristics of the board, divided by 8.
* The formula thus is : Startup Time = (ticks + 1) * 8 / ADC Clock
*/
- ticks = round_up((st->startup_time * adc_clk /
- 1000000) - 1, 8) / 8;
+ ticks = round_up((st->startup_time * adc_clk_khz /
+ 1000) - 1, 8) / 8;
/*
* a minimal Sample and Hold Time is necessary for the ADC to guarantee
* the best converted final value between two channels selection
* The formula thus is : Sample and Hold Time = (shtim + 1) / ADCClock
*/
- shtim = round_up((st->sample_hold_time * adc_clk /
- 1000000) - 1, 1);
+ shtim = round_up((st->sample_hold_time * adc_clk_khz /
+ 1000) - 1, 1);
reg = AT91_ADC_PRESCAL_(prsc) & AT91_ADC_PRESCAL;
reg |= AT91_ADC_STARTUP_(ticks) & AT91_ADC_STARTUP;
--
1.7.10
More information about the linux-arm-kernel
mailing list