[PATCH 1/6] ARM: OMAP2+: Remove board-4430sdp.c

[Olof Johansson]

Hi,


On Sat, Jul 6, 2013 at 6:36 AM, Russell King - ARM Linux
<linux at arm.linux.org.uk> wrote:

> With that worked out, throwing my standard printascii() hack into the
> kernel results in boot messages... up to the point where the timer is
> calibrated.  So, it looks like either interrupts, clocks, or the OMAP
> timers are non-functional with DT based kernels on the SDP board.
>
> Any ideas?

I'm a bit late to the party due to travel and other things going on,
but I have the exact same thing happening with multi_v7_defconfig on
my Panda ES right now -- it gets stuck on calibrating delay loop. I
needed to enable DEBUG_LL and early printk to not just get a dead
system though.

What happened in my case was that MACH_OMAP4 was no longer enabled so
clocks weren't registered. I wonder if we can improve debugability of
that somehow.

Before Arnd's patch to flip the MACH_OMAP2PLUS option around, they got
enabled by default I think. So now I needed:

-CONFIG_ARCH_OMAP2PLUS=y
+CONFIG_ARCH_OMAP3=y
+CONFIG_ARCH_OMAP4=y
 CONFIG_SOC_OMAP5=y
+CONFIG_SOC_AM33XX=y

...in the defconfig.

This is pretty painful, and I don't know if we want to rethink Arnd's
patch since it will break existing defconfigs out there that rely on
OMAP2PLUS enabling the socs instead of the other way around. Opinions?


-Olof