[PATCH v3 0/6] ARM: davinci: da850: add ethernet driver DT support

[Sekhar Nori]

On 7/11/2013 10:42 PM, Prabhakar Lad wrote:
> Hi Sekhar,
> 
> On Sun, Jun 23, 2013 at 8:30 PM, Prabhakar Lad
> <prabhakar.csengg at gmail.com> wrote:
>> From: "Lad, Prabhakar" <prabhakar.csengg at gmail.com>
>>
>> This patch set enables Ethernet support through device tree model.
>> This patch set enables mii interface only and is being tested to boot via
>> rootfs. The rmii phy is present on the i2c gpio expander chip (UI board)
>> for which yet support needs to be added, once the DT support for the chip
>> is enabled, enabling rmii will be subsequnet patch.
>>
>> Changes for v2:
>> 1: Enabled mdio device.
>> 2: Fixed clock lookup.
>>
>> Changes for v3:
>> 1: Fixed review comments pointed out by Sekhar.
>>
>> Lad, Prabhakar (6):
>>   ARM: davinci: da8xx: fix clock lookup for mdio device
>>   ARM: davinci: da850: add DT node for mdio device
>>   ARM: davinci: da850: add OF_DEV_AUXDATA entry for mdio.
>>   ARM: davinci: da850: add DT node for eth0.
>>   ARM: davinci: da850: add OF_DEV_AUXDATA entry for eth0.
>>   ARM: davinci: da850: configure system configuration chip(CFGCHIP3)
>>     for emac
>>
> gentle ping..

I haven't been able to get to reviewing patches meant for v3.12 yet.
Most probably will happen next week.

Thanks,
Sekhar