NSA310 + DT

[tibor at harsszegi.com]

Hi,

> >b.) uart0 is not recognized at all during boot, I cannot see that
> >8250 would recognize the UART at the mmaped area, however the .DTS
> >config seems fine
> >
> >Do you see anything like:
> >
> >Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
> >f1012000.serial: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A
> >console [ttyS0] enabled
> >f1012100.serial: ttyS1 at MMIO 0xf1012100 (irq = 34) is a 16550A
> >
> 
> None at all. I only see the first "Serial:" line, then
> nothing else, seems like the UART0 is stucked, badly mapped/initialized
> at that time.
> 
> This suggests you are missing SERIAL_OF_PLATFORM.
> 
> Try
> 
> make kirkwood_defconfig
> make
> 
> and see if that kernel works any better.
> 

Aok, will keep you posted.
Thanks a lot!!
Cheers,
t.