[PATCH 09/12] ARM: DRA7: hwmod: Create initial DRA7XX SoC data

[Rajendra Nayak]

On Tuesday 09 July 2013 02:01 PM, Tony Lindgren wrote:
> * Rajendra Nayak <rnayak at ti.com> [130709 00:39]:
>> From: Ambresh K <ambresh at ti.com>
> 
>> --- /dev/null
>> +++ b/arch/arm/mach-omap2/omap_hwmod_7xx_data.c
> ...
> 
>> +/* dma_system */
>> +static struct omap_hwmod_irq_info dra7xx_dma_system_irqs[] = {
>> +	{ .name = "0", .irq = 12 + DRA7XX_IRQ_GIC_START },
>> +	{ .name = "1", .irq = 13 + DRA7XX_IRQ_GIC_START },
>> +	{ .name = "2", .irq = 14 + DRA7XX_IRQ_GIC_START },
>> +	{ .name = "3", .irq = 15 + DRA7XX_IRQ_GIC_START },
>> +	{ .irq = -1 }
>> +};
> 
> I think these should no longer be needed?

These are needed only for dma because mach-omap2/dma.c still creates
devices from hmwod and which are used by plat/dma.c.
These irqs for sdma exist even in the cleaned up omap4 and omap5 hmwod files.
I'll try and get rid of that dependency of plat/dma on mach/dma to create devices.

> 
> In general, we must move the hwmod stuff to drivers/bus and start
> parsing the data from device tree along the lines Tero is doing
> for the clock data.

We already have irq/dma and iospace moved to DT (some iospace info still
exists because of non-DT drivers). With Teros patches to move clock data we
should be able to pass the main_clk and all interface level clock info too
from DT.

> 
> What's the plan for doing that?
> 
> Regards,
> 
> Tony
>