Chipidea usb otg support for IMX/MXS (device functionality)

[Marek Vasut]

Hi Peter,

> > -----Original Message-----
> > From: Marek Vasut [mailto:marex at denx.de]
> > Sent: Sunday, July 07, 2013 9:10 AM
> > To: Chen Peter-B29397
> > Cc: shawn.guo at linaro.org; Michael Grzeschik; maxime.ripard at free-
> > electrons.com; Hector Palacios; linux-usb at vger.kernel.org;
> > s.hauer at pengutronix.de; alexander.shishkin at linux.intel.com; Estevam
> > Fabio-R49496; Marc Kleine-Budde; m.grzeschik at pengutronix.de; linux-arm-
> > kernel at lists.infradead.org
> > Subject: Re: Chipidea usb otg support for IMX/MXS (device functionality)
> > 
> > Hi Peter,
> > 
> > > > Where can I measure this?
> > > > 
> > > > > Two possible reasons:
> > > > > 
> > > > > 1. You have not gpio control for vbus toggle when role switches.
> > > > 
> > > > This works well.
> > > > 
> > > > > 2. Your hardware has some problems that the vbus can't lower than
> > 
> > 0.8v.
> > 
> > > > How can I check that?
> > > 
> > > Just measure the voltage of your otg vbus pin.
> > 
> > It's 2.5 volt for me. What am I supposed to observe happening there?
> 
> http://marc.info/?l=linux-usb&m=137242465920952&w=2

Dang, must have missed that one, sorry.

The VBUS is slowly discharging from around 5V to 2.5V , what does that tell me?

Best regards,
Marek Vasut