[PATCH 4/9] clocksource: dw_apb_timer: use the eoi callback to clear pending interrupts

[Heiko Stübner]

this patch should have had a

From: Ulrich Prinz <ulrich.prinz at googlemail.com>

sorry for the mistake

Am Samstag, 6. Juli 2013, 00:53:36 schrieb Heiko Stübner:
> Some timer variants have different mechanisms to clear a pending timer
> interrupt. Therefore don't hardcode the reading of the eoi register to
> clear them, but instead use the already existing eoi callback for this.
> 
> Signed-off-by: Ulrich Prinz <ulrich.prinz at googlemail.com>
> ---
>  drivers/clocksource/dw_apb_timer.c |   11 +++++++----
>  1 file changed, 7 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/clocksource/dw_apb_timer.c
> b/drivers/clocksource/dw_apb_timer.c index bd45351..5f80a30 100644
> --- a/drivers/clocksource/dw_apb_timer.c
> +++ b/drivers/clocksource/dw_apb_timer.c
> @@ -121,11 +121,14 @@ static irqreturn_t dw_apb_clockevent_irq(int irq,
> void *data) return IRQ_HANDLED;
>  }
> 
> -static void apbt_enable_int(struct dw_apb_timer *timer)
> +static void apbt_enable_int(struct dw_apb_clock_event_device *dw_ced)
>  {
> +	struct dw_apb_timer *timer = &dw_ced->timer;
>  	unsigned long ctrl = apbt_readl(timer, timer->reg_control);
> +
>  	/* clear pending intr */
> -	apbt_readl(timer, timer->reg_eoi);
> +	if (dw_ced->eoi)
> +		dw_ced->eoi(timer);
>  	ctrl &= ~APBTMR_CONTROL_INT;
>  	apbt_writel(timer, ctrl, timer->reg_control);
>  }
> @@ -200,7 +203,7 @@ static void apbt_set_mode(enum clock_event_mode mode,
>  		break;
> 
>  	case CLOCK_EVT_MODE_RESUME:
> -		apbt_enable_int(timer);
> +		apbt_enable_int(dw_ced);
>  		break;
>  	}
>  }
> @@ -325,7 +328,7 @@ void dw_apb_clockevent_register(struct
> dw_apb_clock_event_device *dw_ced)
> 
>  	apbt_writel(timer, 0, timer->reg_control);
>  	clockevents_register_device(&dw_ced->ced);
> -	apbt_enable_int(timer);
> +	apbt_enable_int(dw_ced);
>  }
> 
>  /**